Mounting Hardware for etrailer 10 Inch Hydraulic Trailer Brake Kit # AKUBRK-35-D
Updated 11/22/2021 | Published 05/03/2017
Products Featured in This Question
Question:
ok. what is hardware is needed to mount the plates to the brake flange? im guessing 7/16 -14 nylocs or flats and locks. sae grade 5 rather than stainless. but im no expert. please include appropriate hardware. thanks and smooth sailing
asked by: Bil G
0
Expert Reply:
For 10 inch brakes like # AKUBRK-35-D you can use nut and lock washer set (8 each) # BRKH10B. If you want to source stainless or galvanized nuts locally then they should be 7/16"-20.
expert reply by:
Michael H
0
Product Page this Question was Asked From
etrailer Hydraulic Trailer Brakes - Uni-Servo - Dacromet - 10" - Left/Right - 3.5K
- Trailer Brakes
- Hydraulic Drum Brakes
- Marine Grade
- Manual Adjust
- Single Servo
- 10 x 2-1/4 Inch Drum
- 3500 lbs Axle
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: etrailer Hydraulic Trailer Brakes - Uni-Servo - Dacromet - 10" - Left/Right - 3.5K
- Q&A: Difference Between etrailer and Demco Hydraulic Trailer Brakes
- Q&A: Replacement Brake Assemblies for Trailer with 10-1/4 inch Drums
- Video: Review of Demco Brake Actuator - DA75 Trailer Drum Brake Actuator Black - DM88CV
- Search Results: surge brake master cylinder
- Shop: Mounting Hardware for 10" Brake Assemblies
- Shop: Demco Hydraulic Trailer Brakes - Uni-Servo - Galvanized - 10" - Left/Right - 3.5K
- Shop: Manual Lock Out Kit for Demco DA75 Trailer Brake Actuators
- Shop: Demco DA75 Trailer Brake Actuator for Drum Brakes - Black Powder Coat - 2" Ball - 7,500 lbs
- Shop: Demco DA86 Brake Actuator for Disc Brakes w/ Lockout, Solenoid, and Cover - 2" Ball - 8,600 lbs
- Search Results: brake lines
- Search Results: installation hitch hardware kit
- Search Results: wheel bearings
- Video: Detailed Breakdown of the Hydraulic Trailer Brake Kit
- Shop: Dexter DX6.6 Drop-N-Go Brake Actuator - Drum Brakes - 2" Ball - Zinc Plated - 6,600 lbs
- Video: All About the Demco Hydraulic Brake Actuator-DM72VR
- Q&A: What Is the Torque Spec for 4 Mounting Bolts Used to Install 10" Trailer Brakes
- Search Results: junction box
- Search Results: 10~2~1
- Search Results: trailer breakaway kit
- Q&A: Why is 10 or 12 Gauge Wire Recommended for Electric Brake Assemblies
- Q&A: Will Water Damage Magnets if Electric Brakes are Installed on Boat Trailer
- Q&A: How Does the Electric Trailer Jack # JET-5000 Wire to a 7-Way
- Q&A: What Size Nuts Are Needed With The Electric Trailer Brake Kit # AKEBRK-35-SA?
Matt M.
11/15/2021
What is the correct torque spec for the 4 backing plate to flange mounting nuts?