Dimensions For The Ventline Ventadome Trailer Roof Vent # V2110SP-24

Question

Question:

Can you provide the actual dimension of the Ventline Ventadome Vent V2110SP-24 that actually penetrates the roof. I know it states 14 1/4 x 14 1/4 rough opening but I would like to know the actual dimension of the unit. Thanks

asked by: David C

0

Expert Reply:

I walked out to our warehouse and pulled the Ventline Ventadome Trailer Roof Vent, part # V2110SP-24, from our inventory to measure.

The outside edge of the vent flange measured approximately 16-1/2 inches square. The actual opening of the vent measured approximately 14-1/2 inches square. The depth of the vent from the inside flange to the outside flange measured approximately 2 inches tall.

I took a picture of Roof Vent # V2110SP-24 and used Photoshop to illustrate the measurements.

expert reply by: Reno H

0

click to enlarge

Answer 1

To get a metal vent cover roof vent on your trailer you would have to replace what you have on your trailer with the part #V2110SP-24 like you mentioned. It does attach by using screws that attach through the outside like what you see in the picture…

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

Hey Moises, the install kit that comes with the Furrion Chill Low Profile RV AC unit #FR79TQ that you referenced includes the wall thermostat, air distribution box, controller, and wiring needed to install the use. The wattage draw is 1,373 watts,…

view full answer...

Answer 7

The Replacement Black Top with Glass Cover for Furrion 2-in-1 Range Oven #FR46NR you mention is actually not going to be a fit for your Dometic Range Oven as this product is intended to only fit the Furrion 2-in-1 range oven FSRE17SABL or FSRE21SABL.…

view full answer...

Answer 8

Hey Dustin, the replacement lid you ordered a few years ago was the part #BVD0449-A01. I know it sucks yours fell apart but these aren't really designed to withstand a hail storm so I am not shocked yours broke apart. Would you prefer metal lid…

view full answer...

Answer 9

Hey Richard, yes the the BAK tonneau cover part #BAK85VR is for sure a fit for your 2000 Chevy Silverado 2500 long bed. Does your truck have the round or square front end? The Silverado generally has the rounder look whereas the C/K was more square.…

view full answer...

Answer 10

Hey Chip, yes I agree the metal lid of the Ventline Ventadome part #V2110SP-24 is going to hold up the best over time which would mean you wouldn't have to worry about replacing the lid for a very long time. How old is the trailer?

view full answer...

Answer 11

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Dimensions For The Ventline Ventadome Trailer Roof Vent # V2110SP-24

Product Page this Question was Asked From

Continue Researching