Roof Vent Recommendation for Metal Roof Lid on 2922 Trailer
Updated 05/16/2017 | Published 05/15/2017
Question:
I have a 2013 Trailmanor model 2922 trailer. The plastic vent covers were damage in a hail storm. The plastic vents are Ventline products. I want to replace it with a metal covered vent, item V2110. Id like to determine if various options are possible. 1 Can I just replace the broken, plastic vent covers on the existing vent assembly with a metal vent cover? 2 If I have to replace the whole thing to get the metal cover, It looks like the metal vent assembly is attached to the roof by screws on the OUTSIDE. However, my existing vents are anchored from inside, via 4 metal brackets that go across each corner of the cutout square in the ceiling. A long screw/bolt goes up into each corner bracket from inside, and then threads into the vent frame, pulling it snug against the outside top of the trailer. Can the V2110 be mounted this way, OR is there a different vent assembly I need to purchase? 3 If a new metal vent assembly is needed, will my existing garnish ring mate with the metal vent assembly? Or, if you have other ideas Id like hear them. I can take pictures if youre not sure what Im describing. Thanks,
asked by: Duane
Expert Reply:
To get a metal vent cover roof vent on your trailer you would have to replace what you have on your trailer with the part # V2110SP-24 like you mentioned. It does attach by using screws that attach through the outside like what you see in the picture I attached.
If your current vent is a Ventline this will mate with the garnish easily.
Product Page this Question was Asked From
Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - Metal
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- No Fan
- Plastic and Metal
- Silver
- Ventline
more information >
Continue Researching
- Shop: Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - Metal
- Q&A: Replacement Roof Vent Cover for Damaged Bathroom Roof Vent
- Shop: Metal Low Profile Replacement Cover
- Q&A: Replacement Roof Vent Cover Recommendation for 2017 Lark Trailer
- Shop: Vent Cover for Ventline Old Style Rounded Dome Trailer Roof Vents - White
- Shop: CE Smith Single Axle Trailer Fender - Pre-Galvanized Steel - 13" Wheels - Qty 1
- Search Results: rv vents and fans
- Shop: CE Smith Single Axle Trailer Fender - 16 Gauge Steel - 13" Wheels - Qty 1
- Q&A: Recommended Vent Cover to Use w/ a 14-1/4" x 14-1/4" Ventline Ventadome Trailer Roof Vent
- Video: Ventline Ventadome Trailer Roof Vent Review
- Shop: Roof Vent Installation Kit - Sealant, Butyl Tape, Screws - White
- Shop: Americana Trailer Wheel Center Cap - Stainless Steel - 4.88" to 4.90" Pilot
- Q&A: Recommended Steel Weld-On Trailer Fender for 13 Inch Wheels
- Q&A: Dimensions For The Ventline Ventadome Trailer Roof Vent # V2110SP-24
- Search Results: trailer hitch
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Video: Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent Spec Review
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Search Results: trailer tires and wheels
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Trailer Wiring
- Search Results: trailer wiring
- Video: Comparing Portable Flat Tow Braking Systems - Curt RVi and Blue Ox Patriot
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Shop: Suspension Enhancement
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Shop: Brake Controller
- Search Results: trailer jack
on RV Vents and Fans
