What Wiring Harness is Needed to Install Tekonsha Prodigy P3 on Motorhome with 2015 F-53 Chassis

Question

Question:

I have a 2015 F53 chassis in my Class A Coachman motorhome. What harness do I use with the Tekonsha 90195 P3?

asked by: Cosby

1

Helpful Expert Reply:

In order to install the Tekonsha Prodigy P3 Trailer Brake Controller # 90195 on your Coachman Motorhome with a 2015 Ford F53 chassis, you will use the Tekonsha Plug-In Wiring Adapter # 3035-P. One end of the adapter will simply plug into the brake controller and the other end will connect to the built-in harness beneath the dash.

If you do not have a 7-way installed, you will also need to install the Hopkins Adapter 4-Pole to 7-Pole and 4-Pole # 37185.

I have included a video review of this harness for you to check out.

expert reply by: Chris R

1

Answer 1

We have two front mount receivers available for a 2004 F-450 cab and chassis. They are Draw-Tite part #65022 and Curt part #31114. I have added links to these parts and their install instructions below. I did some geometry with your 8 on 9 inch lug…

view full answer...

Answer 2

The factory brake controller port for your 2019 Coachmen Mirada that's built on the Ford F-53 should be located on the left hand side of the steering column support, which is near the emergency brake pedal. I have attached an image that gives a…

view full answer...

Answer 3

When plugging in the brake controller adapter part #3035-P on a 2018 Ford F-53 Chassis, the vehicle's wiring harness will not be plugged into any other plug. It will be a dangling free behind a plastic black cover inches to the left of the the…

view full answer...

Answer 4

The factory trailer brake controller port in your 2020 Fleetwood Flair built on the 2019 Ford F-53 chassis should be located to the left of the steering column near the emergency brake pedal as shown in the included diagram. Now it is possible that…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 9

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 12

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

What Wiring Harness is Needed to Install Tekonsha Prodigy P3 on Motorhome with 2015 F-53 Chassis

Featured Help Information

Miscellaneous Media

Continue Researching