What are the Dimensions of the Mounting Bracket of the Replacement Sidewind Crank Handle
Updated 02/25/2017 | Published 02/24/2017
Question:
Whats the dimension of the opening between the mounting bracket?
asked by: Kirk H
1
Helpful Expert Reply:
I went out to our warehouse and measured the end of the Sidewind Crank, # TJD-12000-HD.
The inside width of the opening measured 1-1/2 inches. The outside measured 1-7/8 inches and the tangs measured 1-3/4 of an inch. In case you want to know, the bolt slot measured 1/2 inch.
expert reply by:
Jared P
1
Product Page this Question was Asked From
Replacement Sidewind Crank for etrailer and Ram Square, Direct Weld Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Sidewind
- etrailer
more information >
Continue Researching
- Video: All You Need to Know About the Buyers Products Traffic Cone Holders
- Search Results: cone holder
- Video: etrailer and Ram Square Sidewind Crank Replacement Review
- Shop: Replacement Sidewind Crank for etrailer and Ram Square, Direct Weld Jacks
- Search Results: trailer jack handles
- Shop: Buyers Products Traffic Cone Holders - Vertical Mount - Black Powder Coat - Qty 1
- Shop: Replacement Crank Handle for etrailer and Ram Manual Landing Gear - 12" L
- Video: Review of etrailer Replacement Return Spring etrailer Ram Square Direct Weld Jack - TJD-12000-RSP
- Video: Review of etrailer Replacement Sidewind Crank TJD-12000 Series Jack - TJD-12000-HD
- Video: Square Direct Weld Jack: The Breakdown
- Q&A: Diameter and Length of Replacement Return Spring for etrailer and Ram Square, Direct Weld Jacks
- Q&A: Determining the Correct Spring Replacement on Sundowner Sunlight Stampede Gooseneck Trailer Jack
- Q&A: Dimensions Of The Replacement Return Spring for etrailer and Ram Square, Direct Weld Jacks
- Q&A: Parts Needed to Operate 25K etrailer Landing Gear Jack on a TopHat Trailer
- Q&A: Length and Radius of Ram Jack Handle # TJD-12000-HD
- Q&A: Replacement Parts for the Square Direct Weld Jacks
- Shop: Replacement Cap for etrailer and Ram Square, Direct Weld, Sidewind Jack - 10K
- Shop: etrailer Square Direct Weld Jack - Drop Leg w/ Spring Return - Sidewind - 25-7/8" Lift - 10K
- Shop: Replacement Handle Shaft for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Shop: Replacement Bearing for etrailer and Ram Square Jacks - 10,000 lbs
- Shop: Trailer Wiring
- Search Results: jack handle
- Q&A: Does the Bulldog Square Jack # BD182815 Come with a Handle