Recommended Front Hitch Receiver For 2004 Jeep TJ

Question

Question:

I was able to pick up a used Meyer plow. I need a front receiver hitch for a 04 Jeep Wrangler tj. It has a tubular front bumper. I think Curt has a frame mount version. What do you reccomend?

asked by: Bill K

0

Expert Reply:

For your 2004 Jeep TJ, I recommend the Curt Front Mount Trailer Hitch Receiver 2", # C31028. This front mounted hitch is compatible with a round bumper. It is an easy bolt on application, but some drilling is required for installation. Access holes may need to be enlarged by drilling, filing, rotary tool. This hitch has the complete hardware kit included and has a vertical load limit of 350 lbs and a line pull rating or 9,000 lbs. This is the only front hitch we currently carry that is compatible with your round bumper.

expert reply by: Jason S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 3

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 4

For a brake controller I would recommend the Prodigy P3 Brake Controller part #90195 for basically every towing situation but especially for an electric over hydraulic setup like what you have. This is our best selling brake controller because of how…

view full answer...

Answer 5

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 6

For your 2004 Jeep Wrangler TJ we have a front hitch that's designed to fit underneath the front bumper with the Curt #C31028 which would be your best option, but there isn't a way to mount a #31408 on top of the bumper that you have.

view full answer...

Answer 7

To add a front mount trailer hitch to your 2002 Jeep TJ with a tube style front bumper you will need to use Curt front mount hitch #C31028. It attaches to the frame of the Jeep and will sit underneath your front bumper.

view full answer...

Answer 8

Just about every full sized domestic SUV and truck will be equipped with a factory hitch and 7-way. If it lacks the factory 7-way, there will be a round US CAR connector under the rear bumper or above the spare tire that would plug into a connector…

view full answer...

Answer 9

The CURT Front Hitch, #31408, attaches to the top of the front bumper on your 2004 Jeep Wrangler. I have included a link to installation instructions and a photo of a similar hitch in the same mounting location for you. The front mount hitch makes a…

view full answer...

Answer 10

The 235/80-16 sizes tires are the closest size that we have to your 9.5-16.5 tires. Your current tires should have a diameter of 30.6" and the 235/80-16 tires measure 30.9" in diameter. When it comes to clearance with your trailer you will…

view full answer...

Recommended Front Hitch Receiver For 2004 Jeep TJ

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching