What Size are the Screws Included with Lippert Kwikee Step Motor Replacement Kit For Pre-IMGL Steps

Updated 08/30/2016 | Published 08/29/2016

Question:

WHAT THREAD SIZE ARE THE 3 SCREWS? 1/4-20 OR SMALLER MAYBE 10-24. 1/4-20 ARE TOO BIG FOR THE GEAR HOUSING. MINE ARE SMALLER ACTUALLY 10-24 TO THREAD INTO HOUSING. LENGTH IS 1 3/4inch NOT COUNTING HEAD. COULD YOU ATTACH A PHOTO OF GEAR AND GEAR TO MOTOR. IS WIRE A SPECIAL TWO WIRE CONNECTOR TO MOTOR.?

asked by: Daniel R

Expert Reply:

I looked through a service manual to determine that # LC379608 is correct for your steps but I didn't have to go too far into that manual. This time I had to go pretty far but I finally found that the bolts included with the replacement motor for pre-IMGL steps are in fact 10mm by 1-3/4 inches!

The included wiring is indeed a 2-wire harness with the unique 2-pin connectors on each end.

I have included an exploded view of how the motor and gear box all go together. It isn't pretty but the original wasn't much to look at either.

expert reply by: Michael H