How to Make 7-Way to 6-Way Square Adapter for Jayco Camper

Question

Question:

I have 1995 Jayco 1206 pop up with an electric fridge. I am looking for a power cord to go from a round 7 pin to the square 6 pin on the trailer that will power the fridge. Do you make one? Or can you tell me where I could get one. Thanks.

asked by: Robert S

0

Expert Reply:

To make a 7-way to 6-way square adapter will require you to get the part # 37995 to use the 6-way end and then wire up a 7-way to it like part # H20043. This will give you the adapter you would need since there isn't one already pre-made.

expert reply by: Jameson C

0

Answer 1

If you have a leaf spring suspension you will select one of two axle over-under kits (sometimes called axle flip kits) for your 1995 Jayco 1206 single-axle pop-up camper trailer based on the axle diameter. Kit #K71-384-00 works with 2-3/8-inch…

view full answer...

Answer 2

A better option based on your bumper dimensions would be a frame mounted spare carrier like the part #CE27310G which is compatible with your bumper dimensions. There wouldn't be a way to mount the #UF15-954730 to what you have.

view full answer...

Answer 3

To make a 7-way to 6-way square adapter will require you to get the part #37995 to use the 6-way end and then wire up a 7-way to it like part #H20043. This will give you the adapter you would need since there isn't one already pre-made.

view full answer...

Answer 4

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 5

It sounds like you are replacing your older 6-pole wiring harness on your Jayco popup camper to a 4-flat connector like #HM48110. When you do this, you will have the black auxiliary wire and the blue brake wire remaining. You will no longer be able…

view full answer...

Answer 6

The Atwood G6A-7 Water Heater is a gas only model. The best option we have for replacement is the Furrion RV Tankless Water Heater part #FR48SR which is also gas only. It should fit right into your existing cutout with little to no modifications…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

How to Make 7-Way to 6-Way Square Adapter for Jayco Camper

Continue Researching