Replacement Bearings for a Kaufman Tilt Trailer with 7,000 lb Axles

Published 07/15/2016

Products Featured in This Question

Grease Seal - Double Lip - 2.250" ID - 3.376" OD - GS-2250DL

(2565)

$14.84

Bearing Kit, 14125A/ 25580 Bearings, 10-36 Seal

(3452)

$42.60

Bearing Kit, 14125A/25580 Bearings, GS-2125DL Seal

(3452)

$38.61

Question:

Hello, I have a kaufman tilt trailer with 2-7000lb axles. The information that came with the trailer says that they are allied axles. I believe these use similar parts to dexter axles but I could be wrong on that. The bearings that it uses are - inner25580, outer14125a, and grease seal2133TB. From what i have been able to figure out the grease seal is the same as 42385 i believe. But that number has been replaced with - GS-2250DL. Is this correct? I see that you have a kit BK3-210 with the correct bearings and also races and a seal, but the seal is different than the 2250dl one. Do you offer a kit with the bearings and seal that I need? I am including a picture of the page from the trailer manual that shows the part numbers. Thanks alot,

asked by: Jed S

Expert Reply:

We have two bearing kits that have the same bearing numbers you need. There is part # BK3-200 that uses the seal part 10-36 which has an inner diameter of 2.25 inches and then we have the part # BK3-210 that uses a seal with an inner diameter of 2.125 inches.

The grease seal part # GS-2250DL that you referenced that you think you need has an inner diameter of 2.25 inches and an outer diameter of 3.376 inches.

This matches what the bearing kit part # BK3-200 has so that would be what you need.

expert reply by: Jameson C