Where Does Curt Trailer Wiring Harness Install on a 2000 Toyota Tundra
Updated 07/07/2016 | Published 07/06/2016
Question:
I have a 2000 Toyota Tundra with an existing trailer wiring connection that was on the truck when I bought it new from factory. The Curt 55367 does not match the existing connection under the rear of the truck close to the rear bumper. There is no blank connection as illustrated in the instructions. As seen in the attached photo the connector tees off the tail light harness. The lighter colored connector to the top-right connects directly to the 4-flat. Suggestions? Thanks
asked by: Glenn
Expert Reply:
It looks like the connector you need is actually already plugged into something which I have pointed out in the picture you sent. The empty plugs on the right side do not seem to match the connector on the Curt wiring harness # C55367 for the 2000 Toyota Tundra. Or, if you can plug it into that lighter connector in the upper right and everything works then you are good to go.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Brake Controller
- Shop: Trailer Wiring
- Search Results: dielectric grease
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: curt 51500
- Search Results: curt 57672
- Search Results: circuit breaker
- Search Results: brake controller
- Search Results: go power
- Q&A: Custom Wiring Harness for a 2000 Toyota Tundra To Tow a Boat Trailer
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional
- Video: A Closer Look at the Mdemo Gopower Solar Charging System
- Video: DIY Install: Tekonsha Prodigy P2 Trailer Brake Controller on your 2002 Toyota Tundra
- Shop: Curt Universal Wiring Kit for Trailer Brake Controllers - 10 Gauge Wires
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Installing a 7-Way Trailer Connection on a 2000 Toyota Tundra
- Shop: Curt Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge
- Q&A: Recommended Hitch and Wiring Harness for a 2000 Toyota Tundra
- Video: Checking Out the Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Shop: Dielectric Grease for Electrical Connectors, 2 oz.
- Shop: Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Q&A: Location Of The Grey Fuse Holder Connector On A 2000 Toyota Tundra
- Q&A: Installing Trailer Wiring Harness On 2000 Toyota Tundra
- Q&A: Can Curt T-Connector be Used to Replace OEM Trailer Wiring on 2000 Toyota Tundra
- Q&A: T-1 Trailer Wiring Harness Recommendation for a 2000 Toyota Tundra
- Video: Set up: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness on a 2019 Nissan Armada
- Video: Review of the Go Power Overlander Solar Charging System with Digital Solar Controller
- Video: Making sure the Redarc Tow-Pro Liberty Brake Controller Fits
- Video: Comparing the Tekonsha Prodigy P3 and Redarc Tow-Pro Liberty Brake Controllers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Custom Fit Vehicle Wiring
