Recommended Truck Bed Bike Rack for a 2015 GMC Canyon with OEM Vinyl Roll-Up Tonneau Cover

Question

Question:

Will this work for the 2015 Canyon with the OEM vinyl roll-up Tonneau cover?

asked by: Alex W

0

Expert Reply:

I have a solution for you but the Swagman # S64702, will not work with a OEM soft tonneau cover.

I would instead recommend the Thule Insta-Gater Pro Truck Bed Bike Rack # TH93VR or a truck tailgate pad like the Thule # TH823PRO.

Due to the mounting design of the OEM soft roll-up tonneau cover, you would not be able to mount the Swagman Bike bar. It would need to supported by a flat support on both the top and the inner side of the bed rail, see attached image, and most soft tonneaus have the mounting bracket on top of or just on the inside of the bed rail preventing this contact.

I have linked the above mentioned products, a few demonstration videos, as well as all the tailgate pads that will fit your Canyon to this page for your convenience.

expert reply by: Jackie C

0

click to enlarge

Answer 1

There isn't an ideal option for your specific tonneau cover. Because the Tonneau overlaps the bed rails, the best option to keep it in place is to use the Saris Traps Fork-Block Bike Carrier Base - Single Track - 47" Long #SATRK14 and then…

view full answer...

Answer 2

Your tonneau covers rail system would interfere with a bed rail style of truck bed bike rack. Would you consider a different style rack like the ones that fit over the rear tailgate? Or attach to truck bed floor.

view full answer...

Answer 3

Hey Doug welcome back! To replace your Dometic Duo-Therm 57915.331, I recommend the Advent Air RV Air Conditioner System item #ADV92SR in white or item #ADV62SR in black. There's no way to just replace your AC unit, you'll need to replace all…

view full answer...

Answer 4

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 5

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 6

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 7

Unfortunately, it will not Brian but thanks for the picture. Our Replacement Fabric for etrailer Slide-Out Toppers has a different attachment method so it will not work with your Solera RV Slide-Out Awning item #LCV000177334. The only replacement…

view full answer...

Answer 8

Hey Mark, since folding tonneau covers like the etrailer part #e73DR end up adding height to the top of the bed rails near the front of the bed they are not ideal for towing a fifth wheel trailer as the nose of the trailer is most likely going to…

view full answer...

Answer 9

Hey Chris, No, there isn't an upgrade kit for your Generation 1 MORryde StepAbove RV Steps to make them a Generation 2. There is a Replacement Leg for MORryde StepAbove RV Steps - 2nd Generation #MR36DR, but because the Generation 1 steps'…

view full answer...

Answer 10

You sure do Thomas and good morning to you as well. The Mach 8 Plus units do indeed require a air distribution box or trim on the interior of your Grand Design. To replace your three Coleman Mach 10 15K AC units, you will need the following parts and…

view full answer...

Recommended Truck Bed Bike Rack for a 2015 GMC Canyon with OEM Vinyl Roll-Up Tonneau Cover

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching