Recommended Low-Profile Trailer Roof Vent for Maximum Garage Clearance

Question

Question:

I have a slide in cab over popup camper. it will only fit in my garage with a roof vent of 2inch over the top or less. I prefer less if possible. How high over the roof will this vent go? If not 2inch or less do you have one that is?

asked by: Chris F

0

Expert Reply:

I went to our warehouse to measure the roof vent that I think will be your best option, Ventline # V2110SP-24. This manual vent has a flat metal lid that extends exactly 2-inches above the top of the mounting flange surface when fully closed. Please refer to the photo I prepared for you.

My contact at Ventline confirmed that this vent has the lowest installed height of their current offerings.

Domed-lid vents like Camco # CAM40480 offer less clearance due to the raised profile of the domed lid.

expert reply by: Adam R

0

click to enlarge

Answer 1

The hole in the roof of the RV has to be around 14-1/4 inches square to install the Camco RV Roof Vent, #CAM40480, but it does not need to be exactly this measurement. Since the opening in your RV roof is 14 x 14, then the fit will be tight but you…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 5

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 6

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 7

Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…

view full answer...

Answer 8

Hey Michael! The 2026 Kia Sportage Hybrid has the 12V battery integrated into the main battery so you won't be making a connection there. What you need to do is run the #C59236 hot lead to the 12V positive jump terminal under the hood. Everything…

view full answer...

Answer 9

Hi Ray! The MORryde GooseTech 5th Wheel to Gooseneck Pin Box for 11.5K to 14K Trailers #MR74MV can definitely be used in a short bed 3/4 ton pickup, like your 2024 Ram 2500. Just be aware that not all trailers have a tapered nose and you may not get…

view full answer...

Answer 10

Hey Edwin, The Skylight #SR89YR will work perfectly fine with your 1-1/4" thick roof on your 2018 Lance 1575, though they typically will require some trimming to the garnish to fit perfectly. You will want to pick up 2 tubes of self leveling…

view full answer...

Recommended Low-Profile Trailer Roof Vent for Maximum Garage Clearance

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching