Wiring Guide for Installing 5th Wheel Landing Gear Motor Switch  

Motor and Switch Kit for Stromberg Carlson Landing Gear - 5,500 lbs #LG-217884 only will use one switch. If you were to use two motors, then dual switches would be used. I've attached a diagram to assist. The input wires from the battery can be…

It sounds like you might have an Ultra-Fab landing gear set. I have included a diagram showing how the system gets wired. On it the white wire is the power wire and the green wire is the ground.

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set #LC358590 has 4 35-amp fuses located on the controller. Attched is a complete wiring diagram for you to check out.

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set #LC675817 or the 4-Point Set #LC358590 can be added to your 2012 Keystone Alpine 5th wheel to give you the auto leveling feature. The current…

The best replacement we have for the Sylvania Microwave SR-11092B is going to be the Greystone Microwave part #324-000105. This microwave comes with its own frame that will need to be used but it should cover your cut out so you will never be able to…

I looked up the dimensions of your Sylvania Microwave SR-11092B (12-1/4" tall x 20" wide x 13" deep) and compared them to that of the Greystone Microwave part #324-000105 (12" tall x 19" wide x 14-5/8" deep). I believe…

The Replacement Switch for Stromberg Carlson Electric Landing Gear #LG-145236 has the wiring colors you specified and will connect in the manner shown in the attached photo. The pink will connect to the positive battery terminal. The short black will…

The max amperage draw for the fifth wheel landing gear motor part #LC141893 that you referenced is 30 amps so a 30 amp breaker like part #7012A would work well.

Normally the SAE number isn't a reliable way to pick out replacement lenses, but we know that the #A32RB is the correct replacement for a lens marked SAE-A-P2-DOT-02 like what you have. For an all new assembly you'd want the part #MC32RB.

It is very possible that the Motor and Switch Kit for Stromberg Carlson Landing Gear part #LG-217884 could fit Atwood Landing Gear Legs as most of these landing gear parts are interchangeable among brands.

For your Fulton Square jack you will use the Replacement Bevel Gear Kit for Fulton Jacks - 800 - 1,200 lbs #F0933302S00 or the Replacement Sidewind Gear Kit for Bulldog or Fulton Jacks - 5,000 lbs #BD500106 depending on the jack's rated…

I went out into our warehouse to grab the gear set part #TJD-7000S-GR that you mentioned and the outer diameter of the larger gear is 1.7 inches with an inner diameter of .53 of an inch. The smaller gear has an outer diameter of 1.39 inches with the…