bing tracking image
Q & A Icon

Recommended Brake Controller to Replace Factory Brake Controller on a 2012 Ford F-350 Lariet  

Updated 04/06/2016 | Published 04/04/2016

Question:

I have a 2012 F350 Lariet that has the factory brake controller. Have not been able to get the performance I am use to out of this. What would be a good replacement controller for this.

0

Expert Reply:

I can help you find a better brake controller than the factory installed one on your 2012 F-350.

I really like the Tekonsha Prodigy P3 # 90195 because it is a proportional brake controller which means it senses how the tow vehicle is slowing or stopping and applies the trailer's brakes with the same intensity. It also has a full display screen instead of codes that need deciphering. The P2 # 90885 is like the P3's little brother, it has all the great qualities but the display of the P2 isn't as user friendly.

To install the aftermarket controller, you will need to unplug the factory harness from the back of the brake controller, and plug in the adapter # 3034-P into the factory wiring harness. Then you will want to mount the controller to the underside of the dash, preferably to the right of the steering column and plug the other end of the wiring adapter into the rear of the P3 or P2 brake controller.

When you start the vehicle, it will show a warning message on the dash display saying that the brake controller has been disabled. The aftermarket controller will be working at this point but if the warning bothers you, your dealer would be able to get into the computer and remove the warning.

I have linked all the products mentioned above, a few installation videos to show you what the recommended brake controllers will look like, and a page with all the brake controllers for your vehicle for your convenience.

expert reply by:
0
Jackie C

Video/Article/FAQ this Question was Asked From

Article or Video
Q & A Icon

Continue Researching