Location of Brake Controller Port on 2016 Ford Explorer with Factory 7-Way

Question

Question:

My 2016 Ford Explorer came with the Class III tow package. from the factory there is a 7 pin connector Id like to use the # 3035-P connector I believe that is the correct one for the life of me I cant find the connector, is it under the driver side, behind the glove box? even the dealer doesnt know :S

asked by: Chris G

1

Helpful Expert Reply:

Brake controller wiring adapter # 3035-P is the correct one for use with a Prodigy P3 controller # 90195 in a 2016 Ford Explorer equipped with the factory 7-way trailer socket. This wiring adapter plugs in at the back of the controller and at the brake controller port. This port is usually located under the dash above your right knee as you sit in the driver's seat.

You will need to remove the black appearance panel at the bottom of the dash. Two screws must be removed to do this. A second panel behind the first one should then slip out of the way. The harness may be tucked up out of the way or secured to other wiring.

You will want to look for a square plug that matches up to the one shown in the linked photo.

expert reply by: Adam R

1

click to enlarge

Answer 1

Hi Christopher! With your 2014 V-Cross Vibe Limited Series M-6504 having a 312 pound hitch weight, I think the Fastway e2 Weight Distribution w/ Sway Control - Trunnion - 4,500 lbs GTW, 450 lbs TW #FA92-00-0450 is going to be a great option. Your…

view full answer...

Answer 2

Hello Valerie, thanks for reaching out. I do have a solution for this, and that is to use bolt-on chain hangers like part #C17005. These brackets bolt to the side of the frame and give you an attachment point for a WD hitch. The Curt MV Weight…

view full answer...

Answer 3

I reached out to my contact at Curt and you will need to use the Curt Short-Arm Weight Distribution System instead of the #C17501 due to the limited clearance due to your trailer having a short tongue. Now the correct system will be dependent on the…

view full answer...

Answer 4

The Reese Friction Sway Control Kit part #83660 uses an 11/32" drill bit for material 1/8" and over and a 9/32" drill bit for material thinner than that. This kit uses the same Self Tapping Screw for Sway Control Ball Plate part #3403…

view full answer...

Answer 5

On a 2016 Ford Explorer the brake controller port is located by the steering column near the steering wheel. Brake controller wiring harness #3035-P is indeed the correct part for your 2016 Ford Explorer with the factory 7-Way trailer connector and a…

view full answer...

Answer 6

I did look at your purchase history and Dexter Trailer Brake Drum for 9,000-lb to 10,000-lb Axles - 12-1/4" - 8 on 6-1/2 - Non-ABS #9-44-1 was purchased here. Thank you! If the magnets are bad and need replacing, the Dexter 10,000 lb trailer…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Location of Brake Controller Port on 2016 Ford Explorer with Factory 7-Way

Continue Researching