Trailer Hitch and Wiring for a 2016 Honda Civic EX Sedan

Published 01/27/2016

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(61)

$204.94

T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(16)

$76.19

Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1

(666)

$15.93

1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs

(2621)

$16.53

2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs

(2621)

$17.55

Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs

(2273)

$49.29

Question:

My question... any holes need to be drilled or the cutting of sheet metal/guards required for the installation of this hitch? Is it possible to install this hitch without putting the car on a lift? If possible please attach the installation manual - Thank You,

asked by: John

Expert Reply:

Drilling is required to install Curt trailer hitch # C11604 but there is no trimming mentioned. I have linked the instructions for you.

You can install the hitch without having the vehicle on a lift. If you have ramps or some jack stands then those will provide you will more space to work.

The recommended ball mount for this hitch is # C45521. For a 1-7/8 inch ball I recommend # 19256 and for a 2 inch ball I recommend # 19258. And for trailer wiring I recommend # 118686 to add a 4-Way flat to the back of the vehicle.

If you want to use the hitch for an accessory such as a bike rack or cargo carrier then you have to make sure the accessory is rated for use with a Class I trailer hitch. Also, with a bike rack, you are limited to 2 bikes maximum on a Class I hitch.

Curt also says you have to use stabilization strap # 18050 when using this hitch for any non-trailer load (such as a bike rack or cargo carrier) per their warranty requirements.