Trailer Connector Location for 2013 Express with Factory Wiring
Published 11/20/2015
Question:
I can find a connector that connects to the factory trailer wiring to go to a 4 plug trailer harness. Any Ideas on finding one? Thank you
asked by: James T
Expert Reply:
If you had a factory connector it would be located at the exterior rear of your vehicle under the bumper most likely on the drivers side. If you have that plug you will need the Hopkins Connector # 41155. If you do not have that plug you would need to run your 4-way from the taillights with the Tow Ready # 118392 wiring harness.
I have linked all the wiring harnesses for your specific vehicle for you convenience.
Product Page this Question was Asked From
Hopkins Plug-In Simple Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- Factory Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: Looking for Hitch for 2026 Toyota BZ
- Q&A: Dimensions for Puck Placement for Install of Reese Elite Rail Kit # RP30126
- Q&A: Is 14 Gauge Wire Too Small for Electric Trailer Brakes
- Q&A: Can an AWD 2015 Ford Edge be Flat Towed Behind a Motorhome
- Q&A: Availability of EcoHitch Front Hitch Installation Video With Active Air Dam Removal for 2024 F-150
- Q&A: How Long Does It Take to Install B&W Turnoverball Underbed Gooseneck Trailer Hitch BWGNRK1020
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps