Distance Latch Sits Above Housing of Door Latch N1980
Published 11/09/2015
Question:
How far out does the latch come out past the edge of the housing? Also, how does it mount? I am planing to use it for a ceiling mounted case holding a flip down tv in an Rv.
asked by: Oystein R
0
Expert Reply:
To install the handle will require you to drill holes along the lip of the door latch.
I went out to our warehouse to get the dimension you are looking for and found that when the latch is pulled up it will stick up 1 inch above the housing.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
"Junior" Non-Locking Steel Flush Door Latch
- Trailer Door Latch
- Latches
- Flush Latch
- Steel
- Non-Locking
- 2-3/4 x 3-3/4 Inch Cutout
- Redline
more information >
Continue Researching
- Search Results: latch
- Video: "Junior" Non-Locking Steel Flush Door Latch: The Breakdown
- Shop: "Junior" Non-Locking Steel Flush Door Latch
- Q&A: What is the Maximum Wall Thickness for the Junior Steel Flush Door Latch to Install Onto
- Q&A: RV Junior Latch that Can be Used with Inside Door Knob
- Q&A: What Keeps the Latch in the "Junior" Non-Locking Steel Flush Door Latch # N1980 Secure
- Q&A: Installing Flush Mounted Latch on Drawers with 3/4 Inch Face
- Shop: "Junior" Locking Steel Flush Door Latch with Inside Release
- Shop: Inside Knob for Locking Stainless Steel Flush Door Latch
- Shop: Ramp Door Hinge - 8-3/16" Long - 1" Pin Diameter - Steel
- Shop: Full Size Non-Locking Steel Flush Door Latch
- Shop: T-Handle Locking Stainless Steel Flush Door Latch
- Q&A: Enclosed Door Latch Recommendation for a 1 inch Thick Door
- Q&A: How to Mount Junior Door Latch # L1930
- Q&A: Inside Knob For Redline Stainless Steel Flush Door Latch