Pipe Mount Trailer Jack Recommendation to fit 2-1/2 inch Pipe Mount on Trailer
Published 11/03/2015
Question:
I need a pipe mount jack with a female pipe on the jack to fit a 2.5male pipe on my roller. Could you please recommend?
asked by: Donald J
Expert Reply:
The Bulldog Round, Pipe-Mount Swivel Jack - Sidewind - 15 inch Lift - 7,000 lbs, item # BD198250, has a male pipe on the jack and a female receiver that welds to the trailer. This female receiver has an inside diameter of just over 2-1/2 inches to fit on the 2-1/2 inch male pipe welded to the jack. This jack utilizes a 5/8 inch pin to secure the jack to the trailer. When fully extended it is 31 inches from where it mounts to jack to the ground.
It sounds like this jack would work well for you, but without knowing more it's hard to say for certain. If nothing else the mount for this jack could easily get welded to your trailer.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement Female Pipe for etrailer and Ram Pipe Mount Swivel Jacks - 5/8" Pin Hole
- Shop: Replacement Female Pipe for etrailer and Ram Pipe Mount Swivel Jacks - 3/4" Pin Hole
- Shop: Replacement Pipe for etrailer and Ram Pipe Mount Swivel Jacks - 2-1/2" - 5/8" Pin Hole