Over-Under Kit for 3,500 Pound Trailer Axle To Provide Additional Clearance

Question

Question:

I have a single 3500 lbs axle and I want to add additional clearance. I want the springs on top of the axle. My axle it slightly flexed. Do you have a conversion kit?

asked by: Gary F

0

Expert Reply:

The over-under kit you will likely want to use is the Dexter Trailer Springs Over-Under Conversion Kit # K71-384-00. This over-under kit fits 2-3/8 inch round axles on trailers with double-eye springs.

If your axle is a 3 inch round axle, and your trailer used double-eye springs, you will want to use kit # K71-385-00.

I have attached a picture showing what the axle set-up will look like with the over-under kit installed. The spring seat will need to be tack welded to the axle once in the correct position.

expert reply by: Victoria B

0

click to enlarge

Answer 1

Hello Robert, Yes, the only difference between the 2 is that the etrailer Enclosed Trailer Transition Plate #e32JR is quantity: 1, and the #e99RV is quantity: 2. Right now it looks like if you wanted a better deal to buy 2 of the #e32JR. It is times…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Over-Under Kit for 3,500 Pound Trailer Axle To Provide Additional Clearance

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching