All About the Hughes Autoformers Safe View Smart Power Inlet Video

The over-under kit you will likely want to use is the Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00. This over-under kit fits 2-3/8 inch round axles on trailers with double-eye springs. If your axle is a 3 inch round axle, and your…

Hi Jeremy, It sounds to me like there was a power surge that ran through your trailer and at minimum the fireplaces took too much voltage and blew. You can try disconnecting them from power for 15 minutes and then retesting them but it sounds like…

Hello Robert, Yes, the only difference between the 2 is that the etrailer Enclosed Trailer Transition Plate #e32JR is quantity: 1, and the #e99RV is quantity: 2. Right now it looks like if you wanted a better deal to buy 2 of the #e32JR. It is times…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Hey Steve, yes the Power Watchdog Surge Protector #HU82VR that you referenced is the most current version.

Hey Marc, yes you can use the 50 amp Power Watchdog Surge Protector #HU82VR with a 30 amp power source. It will work just fine without any issues.

Great question! There is actually another metal pin inside the rotating socket like what we see with the 50 Amp Hughes Autoformers Safe View Smart Power Inlet #HU27VR. This means you can use a power cord like the Camco #CAM55542 to connect to the…

Hey Barry! The #HU82VR you were looking at is the Gen II model. We list the manufacturer part number and name at the bottom of the description which shows this is the Gen II. I also attached a picture which shows the same thing. If you need anything…

The diameter of the round part that goes in the RV is 2-5/8 inches on the 50 amp Hughes Autoformers Safe View Smart Power Inlet #HU27VR.

Hey Dave! The input for the 50A Power Watchdog Surge Protector #HU82VR is at the bottom while the output is at the top. I'm attaching a clip from the instructions on Hughes site so you can see the correct orientation. I've requested for the…

The groove inside the J-Channel Trim for Enclosed Trailer #362415-955 measures 3/16" wide x 1/8" tall with the trim laying flat so that should give you a good idea what kind of diamond plate will fit.

If you're only wanting to setup AC service in your enclosed trailer then you could choose pretty much any 30 or 50 amp power inlet you wanted and then just run the appropriate gauge wire between the inlet and your panel. You can definitely…