Can a 2008 Chevy Silverado Handle a 2400 Pound Slide-in Camper

Question

Question:

2400 pound slide in camper can we put this camper on our 2008 silverado? The gvwr is 6400, gawr frt. is 3950 and the gawr rr is 3750. The cargo weight rating is 1028 pounds. We have installed on our truck TI GMRTT15s. I was told they are rated for 7000 pounds. All these numbers mean nothing to me and I just want to put the camper on our truck. Thanking you in advance.

asked by: Janet C

1

Helpful Expert Reply:

The GVWR is the gross vehicle weight rating. This is the most the vehicle can weigh including cargo, passengers, gas, everything. The GAWR is the gross axle weight rating which is 3,950 pounds for the front and 3,750 for the rear.

The cargo weight rating could be what the bed itself is rated to carry or what can be carried in the cab. Usually for the bed they use the term payload. Adding helper springs will not increase the capacity of the truck. Since the rear axle is rated for 3,750 pounds the 2,400 pound slide in camper would be fine on your 2008 Chevy Silverado.

expert reply by: Michael H

1

Answer 1

Timbren likes to recommend 1 inch between the axle and the Timbren when the truck is unloaded. We have found that this works the best. This allows the suspension to feel when the vehicle is unloaded and still gives you support when needed when…

view full answer...

Answer 2

If your 2002 Chevy Silverado 1500 is leaning to the left, I assume you have come to us because you are carrying a heavy load and this is when it is occurring. If so, we have exactly what you need to fix the issue; if it is happening at all times you…

view full answer...

Answer 3

I'm happy to help you with that application. For your 2000 GMC Sierra 2500 4WD there are three SumoSpring options for your truck. If you will be doing normal towing and payloads then I recommend the SumoSprings Solo Custom Helper Springs…

view full answer...

Answer 4

I attached a picture that shows how the Timbren #TGMRTT35D that you referenced gets assembled. The spacer #TA25722-90P00 you referenced would go between the numbers 2 and 3 and you'd be set. See attached picture. You will need to provide a longer…

view full answer...

Answer 5

The difference between the 2007 Chevy Silverado 2500 and the 3500 series trucks is the weight capacity. The 3500 is going to have a higher weight capacity than the 2500. I spoke with the engineer at Timbren and he told me that the TImbren part…

view full answer...

Answer 6

The kit you referenced is actually designed for heavier duty versions of the Silverado like the 2500 and the 3500. I wish SumoSprings offered lift spacers for their kits but they do not currently. Best solution will be to use the #TGMRCK25S which…

view full answer...

Answer 7

Timbrens would be the way to go since you are hauling quite a bit of weight. So for your 2008 Chevy Silverado 2500 you'd want the part #TGMRCK25S which can give you up to an additional 6,000 lb of suspension support. You should note that this kit…

view full answer...

Answer 8

Where you'll attach the pivot arms on the B&W Patriot #BWRVK3255 just depends on how much clearance you need from the cab of the truck, but in most cases you'll be just fine using the closest setting to the cab. You'll want to make…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Hello Mel, great question! Yes, the Torklift tie downs part #TL66FV will fit your 2006 GMC Sierra 2500HD crew cab with the 8 foot bed, provided your truck does not have running boards or cab length boards that extend under the bed, and you are not…

view full answer...

Answer 12

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Can a 2008 Chevy Silverado Handle a 2400 Pound Slide-in Camper

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching