Which Side Is The Lead Leg For The Landing Gear On 2008 Montana Trailer
Updated 07/29/2015 | Published 07/28/2015
Products Featured in This Question
Question:
Landing Gear on a 2008 Montana - which is the lead leg and which is the following leg looking from the back of the trailer.
asked by: Perry F
Expert Reply:
The lead leg of a landing gear for a trailer is typically on the driver's side of the trailer, so it would be on the left side when looking at the trailer from the rear.
The easiest way to tell is to open the access door for the landing gear and see which gear has the motor or gear box attached at the top of the landing gear. check out the attached photo that shows what the lead leg would look like for a manual landing gear system like part # LG-183708.
For a landing gear system that has a motor the gear box would have an electric motor attached to it like part # LG-1.
Product Page this Question was Asked From
Stromberg Carlson Manual Landing Gear Set - Weld On - 34-7/8" Lift - 8,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 7001 - 8000 lbs
- Manual Jack
- 35 Inch Lift
- Weld-On
- 2 Jacks
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Video: Feature Breakdown: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear - 33-1/2" Long
- Video: An In-Depth Look at the Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Video: Complete Breakdown of the Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Video: Review of Stromberg Carlson Camper Jack - Trailer Jack - 7145-943-00
- Q&A: Replacement Landing Gear Legs for Venture 900 Landing Gear
- Shop: Replacement Follow Leg for Keystone Montana 5th Wheel Landing Gear
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: Replacement Reduction Box Retainer for Stromberg Carlson Electric Landing Gear Set
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Shop: Replacement Lead Leg for Keystone Montana 5th Wheel Landing Gear
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 5,500 lbs
- Q&A: Difference Between Stromberg Carlson LG-183708 and LG-1 Fifth Wheel Landing Gear
- Q&A: Can A Motor Be Added To The Stromberg Carlson Manual Landing Gear Set LG-183708?
- Q&A: Recommended Replacement Lead Leg for Bent Leg on Jayco 5th Wheel Trailer
- Q&A: Replacement Landing Gear Follow Leg for 2003 Keystone Everest
- Q&A: Replacement Landing Gear for VMC900R
- Q&A: Motor Kit Needed to Convert etrailer Landing Gear RVLG-8000 to Powered
- Article: Best Landing Gear
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Article: How to Replace an RV Roof Vent Cover
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Converting Your RV Water Heater to Tankless
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Performance Chips and Modules