2-1/2 inch Long Trailer Wheel Stud Recommendation
Updated 06/09/2015 | Published 06/08/2015
Question:
I need trailer wheel studs in 12mm X 1.25 pitch and 2.5-3 inches long. Knurl diameter is approx. 0.530 inches. Been hard to find anything longer than 2 inches. 4 lug trailer axle. Thanks,
asked by: Stan B
1
Helpful Expert Reply:
Based on what you listed you are looking the part # RG03-080 would be the best option that we offer. This is 1/2 inch in diameter, is 2-3/4 inches in length, and the knurl diameter is .54 of an inch.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Replacement Trailer Hub Wheel Stud, Drive-In, 1/2" x 2-3/4" - Qty 4
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 1/2 Inch Diameter
- Drive-In Stud
- 2-3/4 Inch Long
- Redline
more information >
Continue Researching
- Q&A: Where are Kenda Trailer Tires Made
- Q&A: How to Determine Bolt Pattern for a Replacement Trailer Wheel
- Q&A: Replacement Trailer Wheel Studs With 1/2 inch Diameter
- Q&A: Recommended Hydraulic Trailer Jack to Work w/a Existing Hydraulic Pump System
- Q&A: Replacement 1/2-20x2.25 Wheel Studs
- Q&A: Length of Catch Arm on UWS Lock Cylinder UWSLOCKCH501 and Can Lock Be Keyed Alike
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Which Hitches are Made in the USA
- Article: Trailer Tire Sizing
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Rust Prevention