How to Tow a Jayco Trailer with a 6-Way Square Connector with a Vehicle that has a 7-Way

Updated 05/14/2015 | Published 05/13/2015

Products Featured in This Question

Curt 6-Pole Square Trailer Wiring Connector Loop - Vehicle and Trailer Ends

(31)

$8.90

7-Way Round RV Style Trailer Connector - Trailer Side

(373)

$13.57

Question:

I need a harness to go from a 1996 Jayco model #1006 ST- J series popup camper trailer 6 pin- 5 male and one female to a round 2009 Honda Pilot. Do you have what I need ?

asked by: Glenn B

Expert Reply:

Sounds like you have a 7-way connector on your 2009 Pilot and are looking for a way to connect it to your Jayco pop up that has one of their square style 6-way connectors.

Since there isn't an exact adapter for what you are trying to do your best option would be to remove the square connector from the trailer and install a # A7WCB in place of it. This will allow your trailer to be towed much easier by other vehicles in the future as well.

You will want to verify the functions of the wires on your trailer by either applying 12 volts to each circuit to see what activates or by tracing them to see where they terminate and then wire the new 7-way according to the diagram I attached.

expert reply by: Jameson C