Troubleshooting Trailer Wheels that Toe Out Toward the Front
Published 04/22/2015
Question:
Hello, I recently purchased 2 of these axles with the EZspindle attached. I just finished installing both axles and I noticed that when looking at the axles from head on, the very back axle wheels are pointed straight towards the front and the nearest axles closest to front wheels are pointed slightly outward toed out towards the front. Obviously the bend in the axle helps for heavy loads, but nothing is loaded on the trailer yet, Is it possible that when the EZspindle/plate on either end of the axle were welded on, that they were not welded on properly. I cannot think of any other reason of why my wheels on that axle would toefoot out toward the front. The only thing I can think of is that the plates on either end of the axle were not welded perfectly straight. Someone suggested to me that I may have received a bad axle. Please let me know what I should do..
asked by: Ryan
Expert Reply:
Sounds like a problem with the suspension. Check the suspension for worn out components are holes that are egg-shaped instead of round where the suspension components come together.
Having your trailer checked is a good idea to verify there are no broken parts such as the axle or springs.
I would recommend looking for a company that sells trailers and/or RVs and has a service department. These guys will probably have the most comprehensive hands on experience with your issue. The other option is going to an automobile alignment shop. I would call ahead to make sure someone there is knowledgeable about trailers.
Product Page this Question was Asked From
Dexter Trailer Axle Beam with EZ-Lube Spindles - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 3500 lbs
- Spindles Only
- 74 Inch Spring Center
- 89 Inch Hub Face
- No Drop or Lift
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Axle w/ Electric Brakes - Easy Grease - 5 on 4-1/2 Bolt Pattern - 95" Long - 3,500 lbs
- Shop: Dexter Trailer Axle w/ Electric Brakes - E-Z Lube - 5 on 4-1/2 Bolt Pattern - 95" - 3,500 lbs
- Shop: Trailer Axle w/ Electric Brakes - 4" Drop - 5 on 4-1/2 Bolt Pattern - 95" Long - 3,500 lbs
- Shop: Trailer Wiring
- Video: A Closer Look at the Dexter 7-Leaf Slipper Spring w/ Hook End for 8,000-lb Trailer Axles
- Q&A: Troubleshooting End of Slipper Spring Popping Out on 2023 Outlaw Gooseneck Flatbed Trailer
- Q&A: What Might Cause Trailer Wheels to Point Different Directions When Backing Up
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: TowSmart Adapter w/ LED Illuminator - 7-Pole to 4-Pole and 5-Pole
- Shop: Replacement Modular Base for TracRac Fixed Mount Ladder Rack - Left Front/Right Rear - Qty 1
- Shop: Dexter Trailer Axle Beam with E-Z Lube Spindles - 94" Long - 7,000 lbs
- Video: Detailed Breakdown of the Pollak 7-Circuit-Breaker Junction Box
- Video: Curt Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger Spec Review
- Shop: Replacement U-Bolt w/Nuts for 8,000-lb, Round Trailer Axles - 9/16" Diameter
- Shop: RV Exterior Lighting
- Shop: RV Interior Lighting
- Q&A: How Does Trickle Charger Connect to Breakaway Battery
- Q&A: How to Test a 7-Way Trailer Connector on a Tow Vehicle
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Q&A: How To Wire and Install On-Board Auxiliary Trailer Battery to Power Lights
- Article: Where to Position the Trailer Axle?
- Q&A: Tips for How to Identify a Trailer Axle
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Search Results: trailer wiring
- Video: Measuring To Choose The Right Trailer Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer tires and wheels
- Shop: Suspension Enhancement
on Trailer Axles
