Will Tear Clearance Light Kit Fit on a Roof that is Slightly Curved
Updated 04/21/2015 | Published 04/20/2015
Question:
These lights look identical to the lights on the roof of my motorhome. The base of my lights look slightly curved though to match the curve of the front of the roof. Can these be applied with the gasket slightly curved?
asked by: Brandon
0
Expert Reply:
A roof with a slight curve should not be a problem for the teardrop marker lights # CB-15AK. But if you notice any gap then you will want to put a bead of sealant such as # 0160297 around the lights to close up that gap. You don't want to use anything that is too extreme because it might not come off!
expert reply by:
Michael H
0
Product Page this Question was Asked From
Clearance Light Kit - Teardrop Shape - Amber - Qty 5
- Vehicle Lights
- Marker Light
- Cab Light
- Multiple Lights
- Incandescent Light
- Light Assembly
- Teardrop
- Amber
- Optronics
more information >
Continue Researching
- Article: Can You Flat Tow a 2025 Chevy Silverado 1500?
- Q&A: Replacement LP Gas Detector for a CCI 7770.2 / Pre Tell 22 Detector
- Article: Trailer Lighting Requirements
- Q&A: Can a Single Attachment Point B&W Companion 5th Wheel Hitch be Used with a Sidewinder Pin Box
- Q&A: How to Use Lithium Batteries With a PD4060K Converter/Panel That Does Not Have the Li Switch
- Article: How to Replace an RV Roof Vent Cover
- Q&A: Best Replacement for Glo-Brite 9402-55-88 Stop Light
- Q&A: Does Demco CoachLink Monitor Work w/ Air Force One Braking System That Didn't Come With it
- Q&A: Replacement Air Conditioner for RV Duo Therm 57915.531
- Q&A: Replacement Jack Leg for HappiJac Truck Camper Jack System Model 4150
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: 4 Common Myths About RV Solar Power
- Article: Ram Trailer Tow Prep Package