Availability of Kodiak Brake Pads for 1996 Champion Boat Trailer

Question

Question:

I have a 1996 champion boat trailer and need brake pads for it. Do you have them

asked by: Mark P

0

Expert Reply:

You will want to check your calipers for the number stamped on the outside between the two bleeder valves. (See image) If the number is 225 (calipers rated for 3,500 lbs - 6,000 lbs), then the correct brake pads are part # K225CP that you referenced.

If you need pads with stainless steel backing plates (if your trailer gets launched in salt water you will want these) you would want part # K225CPSS.

expert reply by: Chris O

0

click to enlarge

Answer 1

The tabs on the outer Kodiak Ceramic Brake Pads #K225CP need to be bent to keep them in place on the caliper. This is done in the linked installation video at the 4:35 mark.

view full answer...

Answer 2

Using compressed air is still the way to go. I have come across many instances of people using this method to push out the piston. And the best part is, it works. If you do not have an air compressor I am sure a local shop would go ahead and do it…

view full answer...

Answer 3

If your disc brakes like the Kodiak Disc Brake Kit #K2R35S are not releasing it is likely an issue with the hydraulic actuator. Oftentimes this is the shock of the actuator having gone bad so it won't release all the way, so that would be the…

view full answer...

Answer 4

The "KTC 7600" stamped on the brake pad doesn't look to be a part number, so I can't cross reference it, but we do know you have Kodiak ceramic brake pads. So to determine the correct brake pads, all you need to do is match up…

view full answer...

Answer 5

An aluminum wheel like the #AM25DR is actually the best option for boat trailers. Aluminum is rustproof which makes it ideal for salt water applications. As long as you're looking for a 14" wheel with a 5 on 4-1/2 bolt pattern this is a…

view full answer...

Answer 6

Yes the double lip grease seals in the TruRyde Bearing Kit, #BK3-300, will work on your horse trailer axle as long as it is the correct size seal for your spindle. I have attached a photo showing how to measure the inner and outer diameter of the…

view full answer...

Answer 7

The correct bearing kit you will need is the part #BK3-300 that you referenced. This comes with bearings you have as well as a grease seal with the same inner diameter of 2.250 and outer diameter of 3.376 that your 2250D has.

view full answer...

Answer 8

The Kodiak Ceramic Brake Pads, part #K225CP includes 4 pads, to replace brake pads on 2 disc brake assemblies.

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Availability of Kodiak Brake Pads for 1996 Champion Boat Trailer

Product Page this Question was Asked From

Continue Researching