
To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Intended for use on 4" square channel bumpers on the rear of many RVs and towable campers, this 2" x 2" hitch receiver is ideal for RV-approved hitch accessories, such as bike racks and cargo carriers.
Features:
Note: For use with RV-approved accessories only.
At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.
WARNING: Cancer and Reproductive Harm - www.p65warnings.ca.gov
Customer Satisfaction Score:
93% were satisfied with this product
7% of customers were not satisfied
Ratings & Reviews
Very easy to install and heavy duty des ign1007727
This hitch has worked perfectly for our scenario and use. This is a very nice well built hitch, Thank-you !406617
Great product. Easy 10 minute install. Adds good utility and cargo capacity to my travel trailer.804841
Snug fit as others have mentioned. Used a rubber mallet to get it fully seated. Holes closest to the camper did not quite clear the bumper. Had to take a drill to them to take about 1/16 more to get the bolts through. Once installed it's solid.693424
Haven’t tested it out yet but it feels sturdy, easy to install and looks good3508840
Not installed yet 3578093
just received today, mounted it on the bumper vertically so as to make a mount for my waste travel tote for my travel trailer, or i can mount horizontally to use my luggage rack.
Shipping was quick.
So far so good.584212
This thing is holding up great. I had a different stile before and it broke driving down the road. Causing my cargo rack to fall off carrying my generator and my bb-qer. But this mount has been amazing1473633
HELLO
I LOOKED AT A LOT OF TRAILER HITCH RECEIVERS.
AND THEY WERE ALL JUNK.
ON TELL I FOUND CURT RV TRAILER RECEIVER
I NEED IT FOR MY BIKE RACK
I LIKE THE WAY IT IS MADE
IT LOOKS GOOD ON MY NEW RV
THANK YOU ETRAILER YOUR RATING IS EXCELLENT
I SENT YOU THE MONEY IT WAS ON MY PORCH IN 3 DAYS
37110
I am using the Curt bumper hitch for my travel trailer . I mounted it to the 4x4 bumper . It fit well and will be perfect for holding my kayaks . Would recommend to anyone , great product !! 814865
Great product, solid and easy to install on our Flagstaff Camper. E-Trailer kept a timely Email contact informing me of the tracking progress on delivery. Thanks for the great product and professional service.817036
I have not used it 3568515
Couldn't find the trailer hitch I needed any where but here!! It was the perfect fit and I would not hesitate ordering from etrailer again!3195205
Hitch mount was as info described. Needed to mount a heavy 4 bike rack on my RV. Arrived on time and fit perfectly. etrailer videos were very helpful in selecting the right hitch for my weight requirements. You took the time to make them to support the products, you earned my business because of it. 819915
Thanks to etrailer and Michelle for helping me select the Curt E-100 4" bumper mount cargo reciever hitch. The quick delivery helped us get on our fall trip accordingly. Definatly the right product for this application.707277
I have a 21.5' Trail-Lite RV that had a plastic bumper. I wanted to put a Bike Rack on the back of the RV, so I bought some 3/16" 4" x 4" square stock and had a welder weld it on the back of the RV. This is a lot heaver duty than a stock bumper. Once the bumper was installed, I bought this Curt bumper hitch, part E-100, from etrailer.com. Installation was a breeze, and only took a few minutes. I used some grease and a small hydraulic jack to encourage the hitch to slide on. You DO NOT need to drill out the holes as some have reported. A 4 pound sledge will encourage the back hitch hole to pop above the 4" bumper. Use some never seize on the threads so it will come apart some day. Here is the finished product, with my e-bike installed. Shipping was quick and FREE! (I ordered over $100 of stuff) 721033
Torqued to spec. and works as expected. We hang a bike rack off of it on the back of a travel trailer. Solid design.
Reason not a 5: There was a slight alignment issue getting the bolts through both sides due to the stampings not being aligned when welded. Once I got the bolts through, no issue, but there was interference with the threads on the stamping; had to turn the bolts through as they would not slip through.
Still would recommend.674835
The receiver was solid and looks great, but I had to elongate the rear holes and use a floor jack to get the bolts through. If it weren’t for the fact that I had to make the modification, I would have given it 5 stars.3583710
Holding up good like it good product good service Thanks!3597761
Awesome product. I did have one problem with it but it was on my end. The bumper on my Keystone Summerland Series Mini was a little to close to the body so I had to flip the mount over to make the bolts work. Shipping was fast!!!! 4 days including the day I ordered. Would have been 3 but something happened with UPS. I will definitely be buying more products from etrailer Corporation.458672
Thank you etrailer, I’ve been looking for this bumper receiver for my 38’ Keystone toy hauler for a bike rack. Ordered and four days later it’s here. Installed in 10mins, fits perfectly. I used a flat washer and nylok nuts instead of nuts supplied. Well built and sturdy.730527

Randall
12/11/2020
Great product, we used it all summer on our travels without any problems.
The Curt trailer hitch is solid as can be and couldn't have been any easier to install. Product arrived ahead of schedule and George at the erailer is great with email communications . I will be purchasing future products from this company. Great job George at etrailer. happy camping407389

Gary B.
7/20/2018
Finally started using it this year it works great!!
Just installed this unit on my travel trailer bumper and it appears to be fairly heavy duty and secure. Did have some trouble getting it on the bumper but used my truck tire jack for leverage & it popped right on (see photo). The receiver is just what I need for my bike rack & 2 bikes that I will be hauling to Florida next month. Safety first & this unit looks well made & will hold to the challenges of the road.599941

Lynn
1/25/2020
After a year & 2 trips to Florida is perfect! No need to tighten the bolts due to vibration & wear & tear from a 45 lb bike rack & 40 lbs of bikes. I am extremely pleased with this receiver!
Super easy installation. Works perfect ??3450638

Kate F.
11/19/2025
Easiest receiver to install Aden! Glad we had the right fit for you. What do you mainly haul with it?
I would highly recommend this hitch reciever. I use it for hauling 250lb.motorcycle and or a generator. Very well built and easy to install!3326126

Gwendolyn Y.
5/21/2025
Looks like you put the hitch to good use for the past year! What kind of camping plans do you have planned this year with the bike?
Do you have a question about this RV and Camper Hitch?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.


























































































































Kyle
12/9/2018
Still holding up great a year later. It easily allows me to carry my cargo receiver which has my generator and a couple five gallon gas cans on the back.