Hey Michael! The etrailer Electric Trailer Jack w/ 7-Way #e74GV you were looking at will definitely have enough lift for your Coleman 13R. This is a great option if you just want to power the jack off the 7-way on your vehicle instead of running it…
Hello Henry, thanks for reaching out. The Replacement Auto-Programmable Controller Panel #LC26TF is the correct replacement for your current Lippert part 366701. We have confirmed this directly with the folks at Lippert.
Electric tongue jacks like the Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black #EJ-3520-BBX are designed to use a 12v power so if you want constant power I recommend using a trailer battery for connection. If you only want…
The Husky Super Brute HSB4000 is an older model which is no longer available. I recommend the Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift Item #JET-5000. It has a 5,000 lb weight capacity which will be plenty.
Hello Andrew, thanks for reaching out. The button panel on the Lippert Smart Jack Electric Trailer Jack #LC643589 unfortunately is not a replaceable part. if your button does not work, the only solution I can offer is to replace the jack. In this…
Hey Ken, thanks for reaching out! You're going to need the Hub Bearing Kit #BK2-100 for your 3,500 lb Dexter Axle. This comes with the inner/outer bearings and races, the grease seal, and a tang washer/cotter pin combination. Were there any other…
Hello Ian, thanks for reaching out. Yes, the Lippert Electric Trailer Jack #LC285318 would be a direct replacement for the Lipper Power Tongue Jack model 285318. The dimensions in the picture you sent are an exact match.
The Electric Jack w/ Footplate and 7-Way Plug #EJ-3527-BBX uses a 7-way RV-style plug. I have included a diagram that shows the pin-out for RV style 7-way plugs. This will show you what each pin does. I have also listed the functions below and linked…
The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack that…
Hello Cash, thanks for reaching out. You are needing an A-frame jack, correct? We do have a good option for you, but there is not anything specifically designed for tailgate clearance. That said, I recommend the following: - etrailer Electric Trailer…
The Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX is meant to be a direct replacement however not all the necessary hardware is included. The remaining items you'll need is the Key Wall Control part #MA00A03550K,…
18 inches of travel for a trailer jack is typically more than needed. You would want to measure from the mounting bracket on your trailer down to the ground to determine what you would need. The range of the #UF38-944017 is 9-1/4 inches retracted and…
etrailer's OptiMate ExpertiseAt etrailer, we offer a comprehensive range of OptiMate products with expert recommendations.Our experienced team is here to assist you in selecting the right battery solutions for your needs.Count on etrailer for tailored advice and exceptional support with OptiMate.
OptiMate: Smart Battery Management
OptiMate provides advanced battery maintenance products designed to prolong battery life and performance.
