1995 Ford F-150 Headache Rack

Hi Hilario, congrats on the new truck! ^___^ If this were my truck and I was installing a retractable cover on it (which I actually did with my Silverado), I would go with the manual RetraxPRO XR Hard Tonneau Cover - Retractable - Aluminum - Matte…

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

Hi Kristian, great question! The etrailer Anti-Rattle Hitch Collar, part #e55YV, works by taking the slack out between your hitch receiver and the shank of your ball mount or hitch-mounted accessory. It clamps around the outside lip of your 2-1/2…

Hey Scott! The etrailer Anti-Rattle Hitch Collar #e55YV is rated for up to 10,000 lbs gross trailer weight and won't reduce the capacity of a properly matched towing setup. As always, your actual towing capacity is determined by the lowest-rated…

Hey Mike, congratulations on the new truck! You can definitely use the two together. The Curt StowPro 2-Ball Mount #C34FR53HY uses a standard 2-1/2" shank, making it a great match for our etrailer Anti-Rattle Hitch Collar #e55YV. It installs…

Hey Greg! The etrailer Anti-Rattle Hitch Collar for 2.5" Hitch Receivers #e55YV is not compatible with a weight distribution hitch. This is really the only restriction for our anti-rattle. If you need an anti-rattle for a weight distribution…

I spoke with DeeZee and they gave me the following dimensions, pictured below, for the DeeZee Aluminum Headache Rack with Sliding Load Stops #DZ95050RB. If your Weatherguard Crossbed Storage Toolbox measures 63"-71" in length then you will…

Hi Dennis! The Hellwig Load Pro 35 Heavy Duty Helper Springs with Custom Mounting Kit - Above Axle #HE93XR can potentially raise an unloaded truck a little, but it's going to be very minimal and will really only happen if your suspension is…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Hey Chris, in the instructions for the B and W Turnoverball gooseneck hitch part #BW73FR that you referenced it says that the inner brackets are not needed if the truck has the inner brackets for the OEM hitch already welded to the truck frame. In…

Hey Craig, thanks for reaching out! I believe the Optronics Fleet LED Trailer Tail Lights w/ Grommets #TLL12RK will work as replacements for your 2008 Featherlite 4926 trailer, but you'll need to confirm this on your end. These lights carry the…

I believe you're looking for a more secure hitch pin solution, in which I have just what you need! Check out the etrailer Trailer Hitch Receiver Lock for 2" Hitch - Flush #e98882 This is a locking hitch pin that will lock through your hitch…