2002 Toyota 4Runner Grille

The BAKFlip MX4 Tonneau Cover #BAK48330 for the 2022 F-250 short bed has 4 panels. While you are using your Demco Autoslide 5th Wheel Hitch #DM8550024 you will be able to keep one panel laying flat on the bed. There are tow ways you can store the…

When you say "Bike started to come off the back of the trailer" does that mean that you are using the T2 Pro XTR #TH69TX on the back of a trailer? If so then that could be the problem. The issue is that there…

The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV will be just fine if you need to lift your 2022 Ford F-250 Super Duty, but it will be good practice to lower the psi rating to 5 prior to lifting the truck. I confirmed this…

Yes, the Firestone Ride-Rite Air Helper Springs #F35FV are compatible with your 2022 Ford F-250 4x4 with factory 5th wheel prep package. This system is compatible with in bed hitches, so it will be a great choice for your truck. I also recommend…

We do have tonneau covers that will be better when hauling a 5th wheel. Folding covers are not the best option because when folded up it sits above the bed rails quite a bit. This could result in damage to your trailer, the tonneau and your 2019…

The pin weight of a 5th wheel trailer will usually be around 20% of the trailer's gross trailer weight (GTW) rating. The only real way to find the loaded pin weight of your 5th wheel trailer would require access to a commercial…

The Demco Hijacker Autoslide 5th Wheel Hitch w/ Slider - Single Jaw - Ford Super Duty Prep Package - 18K, part #DM8550024, weighs approximately 305 lbs.

You are right that the strap you mentioned isn't the correct fit, and I checked with Thule and there isn't a standalone strap available for a T2 Pro XT, but there is still an option for you. What you would need instead…

The rear wheel tray of your Thule T2 Pro XTR part #TH83JV for 2-bikes or #TH69JV for 4-bikes is designed to easily slide back and forth to accommodate varying wheelbases like what you have. It's really just a matter of grabbing the…

You will want the hitch to be set at the height that 1) allows the trailer to be level, and 2) allows you a minimum of 6 inches between the bottom of the trailer loft and the top of the bed rails. The fifth wheel hitches offer several inches of up…

When adjusting the arms of the #BWRVK3305, you have the option of setting up so the king pin will sit 3 inches forward or 1 inch forward of the axle. I'd set it up at the tallest height, 18-3/4 inches above the floor of the truck bed…

Yes, trying to couple at an angle with the Demco Hijacker Autoslide #DM8550034 is actually not recommended. The head is fairly hard to move but you should be able to get it. It'll get easier with use. One method that might help is…