Hey Adam, thanks for reaching out. Yes, I think you can make the Yakima SkyBox NX Skinny #Y93QD and FrontLoader #Y02103 work together on your 2022 Honda HR-V. The SkyBox NX Skinny is 26-1/2" wide and the FrontLoader takes up about 7" of…
Hey Jonathon. Both the Yakima CBX XXL item #Y73QD and the Thule Motion 3 item #TH59PN are going to work with your 2025 Nissan Armada's factory crossbars. I recommend the Yakima CBX XXL Rooftop Cargo Box item #Y73QD. It's been specifically…
Hello Heather, I am happy to help, but I am going to need a little more information about your setup before I can recommend the right cargo box. For your 2024 Toyota 4Runner, I would replace the factory crossbars with the Thule WingBar Evo Roof Rack…
You bet, Alan. That’s exactly the kind of versatility the Yakima SkyBox NX Skinny Rooftop Cargo Box (Black Carbonite) #Y93QD is designed for. Since its only 26-1/2inch wide, it leaves enough room on most standard crossbars like a 54inch or 60inch bar…
Hey Gary, so if you can take one roof rack measurement on your 2018 Honda CR-V we can determine if the Thule Motion 3 #TH77PN will allow the rear hatch to open. Measure from the center of the front crossbar back to the rear hatch seam. If that…
Hey Matt, thanks for reaching out! Here are the internal dimensions for those cargo boxes you asked about, as well as a snapshot of the whole file that Yakima has on their website (and a link to it!) concerning box sizing: - Yakima CBX LG #Y63QD -…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
Thank you for the information! It sounds like your 2020 Toyota 4Runner TRD Pro has the raised rails and OEM crossbar setup that we'd find on the standard 2020 Toyota 4Runner. This has very low clearance under the factory crossbars so it's…
Good question Matt, you've definitely done your homework! Yes, your understanding is correct. The Replacement Fast Grip Clamp #TH94JV is the same mounting clamp used on the Thule Pulse Large cargo box #TH615. The FastGrip clamps are designed to…
For your 2022 Mazda CX-5 I recommend the Thule Force XT Sport Rooftop Cargo Box - 11 cu ft - Black AeroSkin item #TH6356B. The Thule Force Cargo Box will fit onto crossbars with a maximum width of 3-1/2 inches and height of 1-11/16 inches. The…
Hey Scott, welcome back! Tthe Thule Motion 3 cargo box part #TH59PN is a really great larger roof cargo box that will work great on your 2024 Subaru Outback Wagon. This has 21 cubic feet of storage space which is a bit on the larger side but if…
Hey Larry, the warranty of just the membrane of the PowerMax Membrane Plus RV Roof Replacement Kit #PM73VR is 10 years. That does not cover the labor, adhesives, sealants/caulking, or underlying wood substrate. What camper are you planning on using…
Great product. fast, professional, and well communicated service. it was a pleasure buying from y'all. thanks again
Tom
Fort Collins, CO
Roof Box with Long Length and Medium Profile
Pack the longer stuff without the bulk. The long length handles items like skis or camping gear, while a medium profile stays aerodynamic and quiet with little impact on mileage. For an easy setup and everyday use, confirm your crossbar spread and rear hatch clearance, and stay mindful of overhead clearance.
It can run quiet on the interstate with little impact on mileage. After installing, take a test drive to confirm. Mount it square on your bars and cinch all 4 attachment points to help reduce movement and wind noise.
Often, but plan your clearances. The medium profile helps overhead, yet you still need to watch low parking garages. Measure roof height with the box installed. For hatch clearance, measure from your front crossbar to the hatch edge and compare to the box's fit notes before mounting.
It's built to handle longer gear, including skis. Measure your skis and compare to the box's interior length spec to confirm fit. If you're near the limit, load tip-first and center them to keep the nose and hatch areas clear.
Yes, but some oversized bars may not fit standard clamps, so a T-slot mounting setup may be needed. Check your bar size against the clamp opening and confirm your crossbar spread fits the listed range. If clamps won't wrap your bars, switching to T-slot hardware can provide a secure fit.
Filters
