Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…
Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…
Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…
Hey Steve, yes the Dexter Nev-R-Adjust Brake Assembly set part #23-458-459 is the correct set for your Airstream based on the part numbers you mentioned. Also the hub/drum part #8-388-80UC3 that you referenced as well would be correct for your…
Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…
Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…
Hey Keith! I can definitely help you find a replacement for your Dometic Duo Therm. However, you're going to have to replace the thermostat and air distribution box as well. Your current setup is for R410A and everything switched to R32 last year…
Hey Matthew, thanks for reaching out. We do have a heat strip kit that will work with the Advent Air RV Air Conditioner System #ADV99QR. For that you'll need the following: - Electric Heat Strip for Advent Air RV Air Conditioners - 5,500 BTU -…
Hey Alan, while the Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners #ADV98SR does have ability to control a furnace it can't be used with a Duo Therm setup like you have. It can only work with Advent Air AC…
Hey Kristoper, we have just what you need with the Dometic Furnace part #DMC54RR which has exact same dimensions as what you had at 16 1/2" W X 7" H X 20" D and also this has same 30k BTU rating so it will work perfectly for you. How…
Hey JT! Sorry to hear about your trouble with the leaf springs. Hopefully there wasn't a lot of damage and everyone stayed safe. From what I have found the 26E-3500 is the same as the Dexter 072-027-00. This is the 6-Leaf Double-Eye Spring for…
Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…
Light up closets, cabinets, and tight spots with an led light you can control right at the fixture. The touch sensor makes quick on/off simple, and these are a handy swap for rv puck lights or broken interior fixtures. Bright output in a small package suits trailers and campers well.
Yes, choose a waterproof or submersible touch sensor LED light for wet locations. Water should not trigger the switch; it's not rain activated. Verify the light's waterproof or submersible rating and be sure any wiring and penetrations are properly sealed. If moisture can reach the wiring, have the area inspected and sealed before installing.
Yes, touch sensor LED puck lights are commonly 12v and can tie into RV wiring. They can be operated by a wall switch and also toggled at the light by touch. Check that your circuit is 12V and that the light uses the same 2-wire hookup. Confirm switch behavior if you want both wall and touch control.
Expect on/off touch control by default; not all are dimmable. Some options include a night light that's really helpful for low light. If you need dimming, verify it's specifically listed; we've seen touch LED models that are not dimmable. For night light use, look for that feature called out in the description.
Start by checking power and ground connections and that the light is mounted solidly. Moisture intrusion or a short can cause odd behavior, so inspect and seal any openings. If the surface is uneven, add a spacer so the housing isn't stressed. Re-test after securing wiring and sealing to reduce false touches.
It can, but confirm measurements first. Some 3" round touch LED lights use mounting holes 2-1/4" center-to-center. Also plan a pass-through for the wires—without a proper hole the light may not sit flush. If your spacing differs, look for a model that matches or be ready to drill new holes or use spacers.
Dome Light
Reading Light
Utility Light
RV Interior Lights Parts or Accessories
Filters
