Dump Trailer Parts - Lifting System

Yes we do; I have added a photo below for you of the dimensions of the Buyers Products Hitch Plate with 2" Receiver Tube - Ford #3371809060A.

The side plates in the Curt Class 5 Universal Weld-on Hitch #C87CR have only been tested by Curt in the vertical position. With that they are not sure how the mounting brackets will hold up if mounted horizontally. I recommend the Buyers Products…

Hello Jeff, thanks for reaching out, and thanks for providing all that info, it really helps. I looked up that Magic Tilt part number PG1090. It is a UFP model A-60 which is super common and we do have a good replacement for this. Take a look at the…

Hey Robert, welcome back! The Dexter 010-036-00, our item #RG06-070, and the Timken item #TMK58ZR are functionally the same grease seal. Timken is known for using higher quality materials in their parts so they do cost noticeably more. Both the item…

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

For a 6 foot wide trailer I recommend the Timbren Axle-Less Trailer Suspension System with Hubs - 5 on 4-1/2 - Regular Tires - 2,000 lbs #A20RS545. This system will allow you to simply attach the assembly to the frame and then use a 2 inch square bar…

The bolt pattern of the Dexter Hydraulic Drum Brake Assembly #23-402-403 that you referenced is is 4.92 inch by 4.92 inch and the diameter of the bolt holes are .545 of an inch.

All the brake controller needs to sense a trailer connection so that you can test it is a slight amperage draw on the output circuit. For that you can use a circuit tester like the part #PTW2993 with one pin grounded and the other on the output pin.…

Since the spare tire carrier #413200 is holding a spare tire and not the weight of the axle/trailer you could use a drive-in stud. But I do like the idea of welding the bolt heads to it better since it was not meant to take wheel studs but can be…

There isn't a set dimension on where to install the hangers of the Single-Axle Trailer Hanger Kit #APS3 when you're using a 26-1/2" leaf spring, as it was really designed around a 25-1/2" leaf spring, so you'll need to tack weld…

The 2018 Highland Ridge Open Range Light lf318rls has a gross vehicle weight rating (GVWR) of 9,995 lbs and an unloaded weight of 7,895 lbs. According to Ford, your 2017 F-150 Ecoboost 3.5L Supercrew 4x4 has a towing capacity of 10,200 lbs. So, you…

For a Lippert 4,400 lb trailer axle the correct bearing kit is the part #BK2-100 which includes inner bearing #L68149, inner race #L68111, outer bearing #L44649, outer race #L44610, grease seal #58846, a cotter pin and a tang washer.