2017 Keystone Sprinter Wide Body Fifth Wheel Blind Spot Detection

Hey Steve, do you know what brand of RV steps you have? If they happen to be the MORryde StepAbove style of steps we have the boot scraper/brush part #MR49RV. Then for a telescoping hand rail we have the MORryde part #MR54BR.

Hey David, The LaSalle Bristol RV Roof Replacement Kit w/ XTRM Membrane #344270KIT30 does need to be installed on a clean surface per the installation instructions: - Make sure the deck is clear of all debris. NOTE: XTRM PLY membrane must be…

Hey Dave, we have the 96 inch long cable part #TC96PB you can use with the Valterra Cable Drain Valve #VAL72RB that you referenced.

If you are looking for a suspension lift for your Forest River Wildwood X-Lite 273QBXL due to its low ride height the best option is absolutely the Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00. The reason is this will give you the…

Hey Bryan, I would go with the Kenda Karrier KR53 part #KE72EV to use as a spare on your 2012 Jayco Jay Flight travel trailer. Its the correct size wheel and tire that you need, it's the Load Range D you need, and also is the best priced option…

Hello Rocky, thanks for reaching out. If your new leaf springs do not have as much of an arch as the old springs they are definitely not going to help your situation if your tires are already rubbing on the fenders. What we would usually do here is…

Hey Dave, yeah the 4,400 lb trailer axles are pretty annoying because unlike basically all other capacity axles they do not follow an industry standard between brands. So because you have a Lippert 4,400 lb axle the correct assemblies would be the…

Hi Stephen, If your weight distribution hitch is overrated for the tongue weight of the trailer then it will over-distribute the weight and start lifting both the trailer tongue and rear of the tow vehicle up. You'll notice handling issues while…

Hey Wayne! Thank you for the picture of your axle tag. Your axle uses #25580 inner and #LM67048 outer bearings with #RG06-070 (10-36) grease seals. For a complete bearing kit you can use the #BK3-300. If you need anything else feel free to reach out…

Hello Bob, thanks for reaching out. Unfortunately there is not a camera available that is compatible with the Voyager WVOS54 monitor. This is an older first gen camera system and they have been discontinued so we do not have a compatible camera. The…

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

The number you mentioned corresponds with a Lippert Ground Control 2.0 so for a control module replacement you would want the part #LC242623.