2-1/2" Round. Waterproof, incandescent trailer light serves as either a side marker light or a clearance light. Built-in reflex reflector. Premium bulb for long life. Recessed mount with grommet (sold separately). Accepts 2-prong plug. P2 rated.
Features:
Specs:
The waterproof construction of this light makes it ideal for use on trailers that may be submerged, like a boat trailer. The circuit board is sealed, which means that water will not damage the diodes or circuit board.
A P2-rated light produces a 45-degree angle of light to either side of its centerline for a total of 90 degrees of coverage. This beam pattern can be seen straight on, but it cannot be seen clearly from the side. So this type of light can be used as either a side marker light or a clearance light, but it cannot function as both. If you need both functions, then you must install 2 separate lights on your trailer - one as a front or rear clearance light and one as a side marker light.
Recessed-mount trailer lights install with a grommet, which is often sold separately. These lights extend past the trailer surface and require a hole for installation. If replacing a light, you can utilize the pre-existing hole. If installing a new light, you will need to cut a hole or use a mounting bracket (sold separately) to complete the installation.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're taking a look at the Peterson trailer clearance or side marker light with reflector. Now if you need to upgrade or replace your existing lights on your trailer, this is going to be a great fit. It's submersible, round, red lens light, so it'll work out great for any brake light function that you might want it to work for on the back of your trailer.If I can find the right angle there, you'll see that reflector allows the light to be visible even when it's not shining. So we'll have good visibility even on those times when we don't have our lights on. But on the back, we'll have our wiring connection to make to a two prong plug. Those are sold separately.
You can find them here at etrailer.com. It's just a little bullet plug there. Male end goes in, plugs right in place. Then we can turn on our light, and, as you can see a light up there for us.This is going to be an incandescent bulb, so it's just going to have that single bulb inside. And this is going to be a premium bulb design to make sure that it lasts for up to 15,000 hours.
So it should be a good long time for us. I don't think that you can get in to replace the bulb, again, since this is submersible, it's pretty sealed up. So once that bulb is no more, or it shorts out on you, then you probably have to replace the whole light. Something to keep in mind there.This is compatible with 12 volt DC systems. Turn that light back on, and I'll turn the lights off in the studio, you can see how bright that is.
So not terribly bright, but enough that will be visible at night. As far as the dimensions with this light, it's about 2-1/2 inches in diameter, and about 7/8 of an inch deep, going from the front to those back terminals there.This works with a grommet, also sold separately. You can find that here again, etrailer.com. Gives a little bit of road shock protection to our light. Kind of finishes it off, and this also is a mounting point.
We have a three inch diameter hole. This will actually seat in that, since it has this little lip here. Holds it in place. And overall just kind of makes our light look more official and nicer. Has the hole in the back to allow our wiring to come through.The light is DOT compliant, P2 rated and made in the USA. That's going to do it for our look at the Peterson trailer clearance or side marker light, with reflector.
Average Customer Rating: 4.9 out of 5 stars (13 Customer Reviews)
2-1/2" Round. Waterproof, incandescent trailer light serves as either a side marker light or a clearance light. Built-in reflex reflector. Premium bulb for long life. Recessed mount with grommet (sold separately). Accepts 2-prong plug. P2 rated.Fit the hole perfectly and working good. Only had the boat in the water maybe 4 times, but everything still works!
Parts arrived on time and in good condition. Installed the 3 trailer lights and all is good.
GREAT product - FAST shipping!
Great part and fast shipping. Great job.
I’ve ordered from etrailer many times. They’re always competitive on price, with a wide selection of options, and have quick shipping. I’ve never been let down or disappointed.
Easy ordering and immediate shipping. Great service!
Great product and fast shipping
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.