etrailer Trailer Fenders
- HP46FR
- 15 Inch Wheels
- 16 Inch Wheels
- For Single-Axle Trailers
- Steel
- 36 Inch Long
- 13 Inch Wide
- Bolt-On
- Weld-On
- No Step
- etrailer
13" Wide x 36" long x 20" tall. This sturdy, rounded fender has a flat back to mount flush with your enclosed trailer. Ribbed, 16-gauge, cold-rolled steel is durable. Bolt or weld onto your trailer.
Features:
- Rounded fender covers 1 tire on your single-axle trailer
- Blocks road debris from hitting other vehicles and helps protect your trailer's cargo
- Flat mounting flange on inner edge lets you mount fender flush with your enclosed trailer
- Close fit keeps dirt from building up between the fender and trailer
- 1" Wide outer edge is rounded
- Ribbed, 16-gauge, cold-rolled steel is tough and sturdy
- Prime and paint the fender to get corrosion protection and to match your trailer's finish
- Weld-on or bolt-on installation
- Requires drilling and purchase of mounting brackets (sold separately) for bolt-on installation
- Made in the USA
Specs:
- Application: single-axle trailers with 15" to 16" diameter wheels
- Dimensions: 36" long x 13" wide x 20" tall
- Quantity: 1 fender
- Weight: 12 lbs
- 1-Year limited warranty
Tips for Replacing and Installing Trailer Fenders
- Do your best to match the dimensions of the new fender to your old one.
- If a fender was damaged during a blowout, use the opposite fender to get the dimensions.
- As with all trailer maintenance, don't forget to chock your wheels before getting started.
- For a bolt-on fender, use your existing mounting hardware, if possible.
- The old mounting bolts or screws might be stripped or rusted, in which case you'll need to tap them out and buy new hardware.
- If removing an old, welded-on fender, either carefully chisel it off yourself or take your trailer to a weld shop to have the fender professionally removed.
- Don't forget to prime and paint the new fender to keep it from rusting (and to match your trailer's finish).
- Before you start drilling, position the fender where you need it and center it over your wheel well.
- Mark where you need to drill (measure twice, drill once).
- Don't tighten down the mounting hardware completely until you're sure the fender is mounted correctly.
MFS00498 Single Axle Trailer Fender - 90-Degree Back - Cold Rolled Steel with Ribs - 15" to 16" Wheels - Quantity 1
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.