See what our Experts say about this Dexter Trailer Breakaway Kit

• Converting Military Trailer Air Over Hydraulic Drum Brakes to Electric Over Hydraulic
  You are correct, there are 4 electric over hydraulic braking systems, from 3 manufacturers, that can be used to eliminate the air over hydraulic actuator on your M200A1 trailer. These systems all require a breakaway system to meet DOT safety standards. I will detail each system for you so you can select the one that will work best for your truck and trailer setup. First, the Dexter Electric Over Hydraulic Brake Actuator, # K71-650, would be a good choice because it will work with the OEM...
  view full answer...
• How to Install the Gel Cell Breakaway Kit for Titan BrakeRite Systems # T4822100
  If you have the Titan BrakeRite II # T4835700 then the battery cable would have been included with your kit. If you check out the diagram I attached you can see how the battery cable installs into the BrakeRite II system. I have also attached a video of this whole kit being installed on a trailer that you can use as a reference. If you jump to the 17:00 mark you can see our installer connecting the breakaway batteries. The breakaway batteries in the Gel Cell Breakaway Kit # T4822100 have...
  view full answer...
  
• Converting from Electric Drum Trailer Brakes to Kodiak Hydraulic Disc Trailer Brakes
  To upgrade your car hauler to Disc Brakes will require several items. Since you are already setup with a brake controller for controlling electric brakes, the easiest way to upgrade would be to add an electric over hydraulic brake actuator to the trailer, like the Titan BrakeRite, # T4813102. The pump in this actuator will be activated by the brake output circuit coming from your brake controller. If your brake controller is proportional, you will need to make sure it is compatible with...
  view full answer...
• Electric Over Hydraulic Brake Actuator For A 20000 Lb Trailer With Disc Brakes
  You mentioned a 20 ton (40000 lbs) tag trailer with disc brakes. If you have a 20 ton trailer it would most likely come with air brakes. Next, you mention a tandem axle trailer with two 10000 lb axles and disc brakes, so I am thinking you were meaning the same 20000 lb trailer. For your 20000 pound trailer with disc brakes, I recommend the Titan BrakeRite I Plug and Play Electric-Hydraulic Actuator Kit, part # T4813102. If the distance between the front axle to the trailer hitch is 16...
  view full answer...
• Parts Needed for Disc Brake Conversion on Take 3 Auto Transport Trailer with Three 7,000-Lb Axles
  I looked up the Take 3 auto transport trailer and it showed it has electric brakes. To convert your electric brakes to disc brakes you will need to use the disc brake conversion kits for 7,000-lb axles with the hub and rotor, hydraulic line kits for three axles, electric over hydraulic actuator, trailer breakaway kit, and a brake controller that is compatible with electric over hydraulic brakes. The disc brake conversion kits will come in pairs, so you will need three sets. These kits...
  view full answer...
• Breakaway Battery Recommendation for a Titan BrakeRite EHB Electric-Hydraulic Actuator # T4813102
  The breakaway battery used with the Titan BrakeRite EHB Electric-Hydraulic Actuator # T4813102 that you referenced must have at least 12 amp hours. The battery will be mounted on the trailer. For a kit that includes both breakaway batteries needed you would want the part # T4822100.
  view full answer...
• Activating Electric Over Hydraulic Trailer Brakes using Integrated Brake Controller on 2010 GMC 3500
  There are two options to activate the electric over hydraulic brakes on your trailer when towing with your 2010 GMC 3500 truck. The first, as you mentioned, would be to use an adapter, which also requires some additional parts. The second option would be to install an aftermarket brake controller which is compatible with electric over hydraulic brakes. If you decide to go with an adapter, you will first need the Titan BrakeRite SD Adapter, part # T4845900. In addition to using the adapter,...
  view full answer...
• Breakaway Battery Kit For Titan BrakeRite Electric-Hydraulic Actuator Kit
  For your Titan BrakeRite # T4813102, you're going to want to use the Gel Cell Breakaway Kit for Titan BrakeRite Systems # T4822100. This kit includes 2 5 amp-hour batteries to be connected in parallel, and it includes a breakaway switch.
  view full answer...
• Will a Battery Charger Charge Both Batteries In Breakaway Kit # T4822100 If Wired in Parallel
  You are correct about how the batteries in the Gel Cell Breakaway Kit for Titan BrakeRite Systems, # T4822100, will be charged. Two batteries are required to meet the amp hour requirement and provide the 15 minute breakaway required by the Department of Transportation). The batteries must be wired in parallel according to the BrakeRite EHB, # T4822500, instructions (link provided for reference). A charger will charge both batteries, though because they are wired in parallel, it will take...
  view full answer...
• Adapter to Convert BrakeRite to Drum Brakes and Connect to Integrated Brake Controller
  To convert a Titan BrakeRite from a disc brake application to a drum you would need the adapter you mentioned part # T4844100 and then to use with integrated brake controllers you would also need the # T4845900. These both plug inline like you mentioned. Then for a breakaway kit you'd want the part # T4822100. You would not need an SD controller. If needed your trailer would have already have that.
  view full answer...
• Electric Over Hydraulic Brake Actuator for Triple Axle Trailer with 7K Axles
  For your triple axle trailer with 7K axles I recommend the Titan BrakeRite II SD, # T4835700. the SD stands for severe duty! With this system I also recommend breakaway kit # T4822100 which was designed for the SD system. If you have a Ford or GM truck with a factory integrated brake controller you will also need adapter # T4845900 so it will work with this electric over hydraulic braking system. If you are using an aftermarket controller make sure that it has an electric over hydraulic...
  view full answer...
• Parts for Switch Over to Disc Brakes From Dexter Electric Drum Brakes With Neve-R-lube Bearings
  For a 7,000 pound Dexter Never Lube axle with 8 on 6-1/2 inch bolt pattern and 9/16 inch wheel studs you will not be able to go with disc brakes on the existing axle. The Problem you will run into is that the center of the hub on your existing brake drum hubs will not work with the slip over disc. Machining the drum off still would not allow the slip over disc to fit correctly. In this case you will need to go with drum brakes like you already have or special order axles that are outfitted...
  view full answer...
• Electric Over Hydraulic Trailer Brake Actuator for a 24,000 Pound Tandem Axle Trailer, Disc Brakes
  For your 24,000 pound trailer with disc brakes, I recommend the Titan BrakeRite I Plug and Play Electric-Hydraulic Actuator Kit, # T4813102. If the distance between the front axle to the trailer hitch is 16 feet or more, it is recommended to use 1/4 inch brake line to help with a better response time of the trailer brakes. I have included a link to the installation details for # T4813102 below. If you do not already have one, you will need a compatible brake controller to operate the BrakeRite....
  view full answer...
• Recommended Electric Over Hydraulic Brake Set Up for 2016 Montana 3710FL 5th Wheel
  I was able to confirm that your Montana 3710FL uses tandem 7000 lb axles. A 7K axle would typically have an 8 on 6-1/2 wheel bolt pattern and the spindles would be compatible with a 25580 inner and an 14125A outer bearing. You'll want to identify the inner and outer wheel bearings used by your current hub/drums. Let me know if your hubs uses a different outer bearing. If your drums use the 25580 inner and 14125A outer bearing, I'd recommend the Kodiak 13 Inch Hub/Rotor Kit, part # K2HR712E....
  view full answer...
• Electric Over Hydraulic Brake Actuator for a 20,000 Pound Tandem Axle Trailer with Disc Brakes
  For your 20,000 pound trailer with disc brakes, I recommend the Titan BrakeRite I Plug and Play Electric-Hydraulic Actuator Kit, # T4813102. I spoke with my contact at Titan to be sure this part would work for your application. He stated that it would work well and also recommended using 1/4 inch brake line if the distance from the front axle to the trailer hitch is 16 feet or more. This larger line will help the response time of the brakes. I have included a link to the installation details...
  view full answer...
• Is Break Away Kit Required for Military M105A2 Trailer Equipped with Titan BrakeRite Actuator
  Because the original Prodigy was not compatible with electric over hydraulic brakes, you would need to upgrade to a Prodigy P2, part # 90885. The regulations regarding the use of a break away system can vary from jurisdiction to jurisdiction, but as a general rule of thumb, we typically state that a break away system is needed for trailers weighing more than 3000 lbs. You would need to check with your state DOT for specifics. If a break away kit is required in your area, I would recommend...
  view full answer...
  
• How are 2 Breakaway Batteries Connected to a Titan BrakeRite II System
  The Titan BrakeRite II Severe-Duty Electric-Hydraulic Actuator, # T4835700, comes with a wiring harness that connects to the breakaway batteries, # T4822100. The two batteries are not connected together but are both run through this harness to the BrakeRite.
  view full answer...
• Does the Tow Vehicle Charge the Batteries of the Titan Gel Cell Breakaway Kit
  I spoke with my contact at Titan about the Gel Cell Breakaway Kit, # T4822100, which is designed for use with the Titan actuator. She told me that yes, the breakaway kit receives a trickle charge from the tow vehicle and does not require an exterior charger. Because the batteries are wired in parallel, it will take longer than a normal charge. You are also correct that the breakaway kit, part # T4822100, and Titan BrakeRite II Severe-Duty Electric-Hydraulic Actuator Kit, part, # T4835700,...
  view full answer...
• Will Titan BrakeRite EHB Work for a 16K Trailer and 2013 GMC Sierra with Factory Brake Controller
  Titan has told me before that the 1500 psi # T4813102 would work well for applications up to 20,000 pounds so 16K should not be a problem. You will need Titan BrakeRite SD Adapter for Ford/Chevy Integral Brake Controllers Item # T4845900 for the integrated brake controller in the vehicle. For a break away kit use # T4822100. I have included a link to the instruction for the EHB for you to view. I have also included a link to an FAQ on what you will need for the conversion beyond the actuator.
  view full answer...
• What Size Battery Will Fit in Replacement Battery Box # TN65117
  The battery that fits in box # TN65117 measures 3.54 inches long, 2.76 inches wide, and 3.93 inches tall. Including the terminals it is 4.17 inches tall. A battery that is at most these dimensions or smaller would fit in the box. It is designed as a replacement for Titan breakaway kit # T4822100. I have included a link to other battery boxes that we carry.
  view full answer...
• Disc Brake and BrakeRite II SD Electric-Hydraulic Actuator Kit With Over the Hub Rotors
  We can absolutely put together everything you need, though the Titan Disc Brake Kit and BrakeRite II SD Electric-Hydraulic Actuator - Tandem, 3,500-lb Axle T4843700 does not come with a brake kit with slip-on rotors. However, all you need for this is the following parts: - Kodiak Disc Brake Kit - 10" Rotor - 5 on 4-1/2" - Dacromet - 3,500 lbs # K2R35D (you will need a quantity of 2 for your tandem axle trailer) - BrakeRite II Electric-Hydraulic Actuator Kit # T4813102 - Titan Hydraulic...
  view full answer...
• Is Titan BrakeRite Electric-Hydraulic Actuator Kit # T4813102 Compatible with 2014 Dodge Ram
  I spoke with my contact at Titan and he said you will have no problem using the Titan BrakeRite I Plug and Play Electric-Hydraulic Actuator Kit # T4813102 on your boat trailer setup that weighs 9,000 pounds as long as your vehicle has an in-cab electric brake controller compatible with electric over hydraulic brakes. I recommend the Gel Cell Breakaway Kit for Titan BrakeRite Systems, # T4822100. This system will engage the trailer brakes should the trailer become detached from the tow...
  view full answer...
• Electric Over Hydraulic Actuator and Breakaway Kit for a 2004 Ford F-350 Super Duty
  The Titan BrakeRite I Plug and Play Electric-Hydraulic Actuator Kit, # T4813102, that you have referenced would be my first choice. The compatible breakaway system is the Gel Cell Breakaway Kit, # T4822100. It includes two 5-amp hour batteries connected in parallel that provides the 15 minutes of breakaway required by the Department of Transportation. You will also need a brake controller that is compatible with electric over hydraulic brakes. If you have a brake controller already and...
  view full answer...
• Adding Electric Over Hydraulic Brake Actuators to 2 Boat Trailers Towed by a 2011 Toyota Tundra
  Starting with the vehicle I recommend the P2, # 90885, because it is easy to set up, easy to use, and it is reliable. If your 2011 Toyota Tundra came with a factory 7-Way then you will also need harness # 3040-P. I have included some links to installation instructions for you. If the truck came with a 4-Way flat trailer connector then you will not use # 3040-P and instead use # ETBC7 to hardwire the 7-Way and controller to the vehicle. I have included some links that explain the ETBC7...
  view full answer...

Do you have a question about this Trailer Breakaway Kit?