Video Transcript for Let’s Check Out the ATAK Solar Motion Light

Speaker 1: Today we're going to be taking a look at the Performance Tools ATAK solar motion light. This is weatherproof light with a max output of 350 lumens. Now this is going to be a really nice weatherproof solar powered motion light. It's going to provide 30 second of illumination whenever that motion is detected.It's constructed from COV technology for increased efficiency and lumens and it has a lifetime LED. So you're not going to have to worry about changing anything out, no bulbs or any batteries to worry about. Any excess power that's accumulated by the solar panel will be stored in the internal lithium battery.

So it's going to be a really efficient light. It is IP rated IP65 so that means it's going to be completely dust proof and also waterproof enough that this can live outside. So no worries about anything getting in there any causing any damage.There is high beam setting and and a low beam setting. So if we dim the lights here, flip the switch on the back, that's going to be or low beam. That's sliding that little slider to the left there or to the first position.

Slide it back to the middle, it goes off. And then to the second position, that'll be our high beam setting. So you'll have those two options to set it to depending on your needs. The output for the high beam is going to be 350 lumens, the low beam will be 175 lumens.This is just an easy install light. You do get a nice large square or rectangle piece of double-sided foam tape so you can just peel off the backing, stick it to the light and mount it up that way.

You can also use the screws that are provided either by themselves or with that double-sided tape. There's only one mounting hole so you'll just put that screw through there, use one of the anchors if you need to depending on where you're going to mount this. And you could always use that second screw to go on the bottom for a little extra support.As far as the specs for this light, the solar charging time is going to be 8 to 10 hours. The voltage from the solar panel is going to be 5.5 volts. The sensor range for this is going to be 25 feet and 120 degrees around the light.

As far as the measurements, it's going to measure four and three-quarters across by three and 15ths, 16ths or pretty close to four inches. And then at it's height at this peek here, it's going to be one and three-quarter inches tall.And that's going to do it for our look at the Performance Tool ATAK solar motion light which is weatherproof and has an output of 350 lumems.