Arrives before Christmas 
This 8-1/4" deep, triple pull-out RV step opens and closes with just 1 hand. Anti-skid tread tape and water collection channels on step surface provide safe entry and exit. Bolts or welds onto your RV frame. Rust-resistant black powder coat.
Features:
Specs:
Will Lippert Pull-Out Steps Work for You?
Pull-out steps are typically installed on travel trailers. The pull-out steps from Lippert are easy to install and fold up underneath the camper for simple storage. To ensure you choose the correct size for your application, there are a few measurements you will need to take.
The Lippert pull-out steps attach the underside of the camper chassis, directly beneath the doorway. To decide which size you'll need, locate the space available underneath your camper that lines up with the door frame, and measure the width and depth. You will need a mounting space that is at least 27-1/2" wide and 12" deep.
If it turns out you have more or less space beneath your doorway, there are other step assemblies available with bracket sizes ranging from 25-1/2" wide to 28" wide. A full list of the available steps is below.
Outriggers - metal brackets that act as an extension (LC301704 - sold separately) - may be needed for installation depending on the model of your original stairs. These provide extra length if the old steps are longer or wider than the new.
Once you know where the mounting bracket will go and what size mounting bracket you need, that spot will be used as the "mounting point" to determine how many steps you will need.
How Many Steps Do You Need?
To determine how many steps you'll need, measure from the mounting point to the ground. This is called the entry height. The entry height should roughly match the height of the steps when they're fully extended, plus 6" to 9" to account for the drop from the bottom step to the ground. This measurement will also tell you how many steps you need.
The chart below displays entry height measurements in the first column. If you determined you need a 25-1/2" mounting bracket, the step part numbers with that width are in the second column. If you determined you need a 25-3/4" mounting bracket, the step part numbers with that width are in the third column. The steps for 27-1/2" mounting bracket widths are in the fourth column, and the steps for 28" mounting bracket widths are in the fifth column. Choose the bracket size that is closest to your measurements without going over.
This page's step assembly is in bold text.
| Entry Height | 25-1/2" Mounting Bracket Width | 25-3/4" Mounting Bracket Width | 27-1/2" Mounting Bracket Width | 28" Mounting Bracket Width |
|---|---|---|---|---|
| 14-1/4" - 17-1/4" | Not available | LC432678 | Not available | Not available |
| 21-1/2" - 24-1/2" | LC432682 | Not available | Not available | Not available |
| 24-1/2" - 27-1/2" | Not available | Not available | LC432687 | Not available |
| 31" - 34" | Not available | Not available | LC432696, LC432690 | Not available |
| 36-3/4" - 39-3/4" | Not available | Not available | Not available | LC432698 |
How Do You Install the Steps?
To install the steps:
-Set aside steps before drilling
-Make sure the bracket is backed up fully against the I-beam on the chassis
-Hardware not included
California residents: click here
Do you have a question about this RV Step?
Condition: Surface Scratches
Notes: Steps have a bend near the top, also with surface scratches, otherwise like new.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.