See what our Experts say about this Lippert RV Slide Out Parts

• Wiring Diagram for the Lippert Polarity Reversing Solenoid LC118246
  Hey Margaret! We do not have an installation video for the Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units item # LC118246. I have attached a wiring diagram below that will show you how to get it set up though.
  view full answer...
• Troubleshooting Lippert Slide Out Controller 13398-DO That Has Error Codes And Only Works In Bypass
  Hey Thad, sorry for the troubles you're having with the Lippert slide out system. The 1-green / 9-red blink code on your Lippert 13398-D0 points to Motor 1 with a Hall-power-short-to-ground fault. Basically, the controller isn't getting the proper encoder/Hall-sensor signal from Motor 1. Lippert says this is usually a wiring problem, which also explains why the motor itself can still move when you use the electronic override. Before replacing anything, I'd do a quick motor-harness swap...
  view full answer...
• Do You Have a Replacement for a Dewald 010634 Solenoid?
  Hey Dianna. I have a solution for you but I don't have the LC136046 which is the Lippert replacement for the Dewald 010634 solenoid. What I do have is the Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units item # LC118246. The LC136046 and item # LC118246 are the same solenoid functionally but they mount differently. The LC136046 mounts using a strap around the motor and the item # LC118246 mounts on a tray beside the motor. Does yours look like the one pictured...
  view full answer...
• Recommended Replacement Solenoid for a Trombetta 214-1211-A61-06
  Hey Rad, so the Trombetta 214-1231-A61-06 and 214-1211-A61-06 are different, but not terribly different. Both Trombetta parts are powered on 12VDC and can handle a 500A inrush, but 214-1211-A61-06 has a max duty cycle of 75A for 5 minutes, 140A for 30 seconds & 214-1231-A61-06 has a max duty cycle of 75A for 2 minutes, and 140A for 30 seconds. So since you have the Trombetta 214-1211-A61-06, you can use the Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units #...
  view full answer...
• Troubleshooting A Lippert Hydraulic Leveling System That Won't Extend The Legs
  Hi William, I'd be willing to bet this is an issue with the solenoid # LC118246 mounted to the pump assembly. Check your wiring connections to make sure they're snug and then test the middle post for 12v power. This is where power comes into the solenoid so if there's no power then you likely have a blown fuse. The outer posts are your retract and extend power so you'll want someone press the retract button and test the post to see whether or not power is crossing over inside the solenoid....
  view full answer...
• Troubleshooting Slide Out That Will Not Close
  Hello Vince, thanks for reaching out. There are a few things you can look at if your slide out will not close. The first thing is to reset the power by disconnecting your RV from shore power for a few minutes then plug it back in. Next check all your slide out fuses, and try resetting the breakers. Also make sure your battery is fully charged, and try resetting your slide controller. If you try all of this and it doesn't fix the problem, it could mean your actuator is bad and needs...
  view full answer...
• Wiring Diagram For The Lippert Polarity Reversing Solenoid
  Yes, I've attached a wiring diagram for the BaseCamp Hydraulic Leveling System, which depicts how the Lippert Polarity Reversing Solenoid # LC118246 is wired into the system. I'll also send a link to the installation instructions for this system separately so that you can review it.
  view full answer...
  
• How to Test Slide-Out Solenoid
  You have already successfully tested the solenoid like the Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units # LC118246. Switching the wires is the exact way you want to test this, and since you have done so, you are right that it is not the motor. What your test indicates is that it is an electrical wiring issue that may require you to have the slide-out serviced by a professional.
  view full answer...
• Wiring Diagram For The Lippert Polarity Reversing Solenoid # LC118246
  I've attached the only wiring diagram that Lippert has listed for the Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units # LC118246 below to help.
  view full answer...
  
• Replacement Trombetta Polarity Reversing Solenoid for Hydraulic Slide-Out on RV
  I did some checking and it looks like Polarity Reversing Solenoid by Trombetta # LC118246 is the correct replacement solenoid for your trailer and hydraulic slide-out.
  view full answer...
• How To Test A Lippert Hydraulic Slide/Leveling System Solenoid And Motor
  The slide out could be malfunctioning for a number of reasons, but the motor or solenoid can very well be the culprit. Below I've attached a snippet from the manual that goes over how to test both the solenoid # LC118246 and the motor so that you can see if either are bad. You'll also want to check the hydraulic fluid reservoir to ensure there's enough fluid, check the lines for any leaks, and then check your electrical connections for any loose or corroded connections.
  view full answer...
  
• How To Determine the Correct Replacement Solenoid for RV Hydraulic Slide-Out On a Keystone Raptor
  The Lippert Replacement Reverse Polarity Solenoid for RV Hydraulic Slide-Outs part # LC136046 and part # LC118246 are the same solenoid but vary in how they mount. The part # LC136046 mounts using a strap around the motor like what you have therefore this is the correct replacement for you whereas the part # LC118246 mounts on a tray beside the motor.
  view full answer...
  
• Troubleshooting Solenoid for Slide-Out Cylinder That Does Not Operate
  You can test the function of the slider's troublesome hydraulic actuator cylinder by swapping the wiring between the two cylinders. If the bad one now works (when connected to the wiring for the other) then you know the issue is not the cylinder, but the wiring. Since you have no hydraulic fluid leaks or other visible issues this does suggest the problem is electrical. Replacing your Trombetta Polarity Reversing Solenoid # LC118246 may be your easiest route.
  view full answer...
• Will Replacement Solenoid Fix Weak Hydraulic Slide-Out
  There is a solenoid like in your photo, and it is possible that Replacement Solenoid # LC118246 will fix your issue. I'm guessing that when opening and closing, doing so one way is causing more problems than the other. If so, what you can do is switch the wiring between the two cylinders to see if the same thing happens, but in reverse, which would indicate the solenoid being the problem and the Replacement Solenoid # LC118246 being what you would need to remedy the problem.
  view full answer...
  
• Troubleshooting Lippert Slide Out Solenoids That Is Not Working On A 2011 Georgetown XL
  The location for the solenoid controller like the Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units # LC118246 will vary and in order to find what you're looking for you're going to need to trace the wiring going to the solenoid. Once you've located the solenoids, you'll want to verify that you are receiving 12V with a circuit tester # PTW2993. If you are not receiving 12V, and your wiring is correct and not damaged, then you'll need to replace the solenoid and...
  view full answer...
• What Replacement Slide-Out Solenoid Fits My 2016 Cedar Creek Fifth-Wheel Trailer?
  The replacement slide-out solenoid motor you need depends on what model of solenoid you currently have installed on your 2016 Cedar Creed 5th wheel trailer. The only replacement solenoid we carry (and the most often we see) is the Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units # LC118246. The absolute safest way to confirm if this part works with your motor is by checking the serial number on your current solenoid. It should match number 214-1231-A61-06. I...
  view full answer...
  
• Correct Replacement Polarity Reversing Solenoid for a 2006 Keystone Montana Mountaineer
  The 214-1231-A61-06 solenoid actually replaced your older 214-1231-A11-06, so the correct replacement for your 06 Keystone Montana Mountaineer is the Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units # LC118246.
  view full answer...
• Troubleshooting Slide-Out Function Where Solenoid Clicks But Doesnt Move Motor
  It sounds like the ground isn't the issue because you bypass that with the cables and still have the clicking of the solenoid # LC118246. It sounds like the solenoid has gone bad and needs replacing. You have confirmed the motor works, so I'd start with testing that solenoid. I recommend testing it using a multimeter like # PT89ZR to see if you are getting the proper voltage before and after the pins. That will also help you further determine if the ground connection is an issue.
  view full answer...
• Troubleshooting Lippert Trailer Slide-Out That Will Slide In But Not Slide Out
  Since your slide's motor works (although only in one direction) we know it is good. This also tells us that the mechanical linkage components that transfer motor power to the slide-out are working too. So as a most-likely candidate the solenoid is it. My contact at Lippert told me your can test the solenoid by connecting the center post to either of the outer posts on the solenoid. Each post will cause the motor to turn in a different direction. If the motor works in both directions when...
  view full answer...
• Slide Out Periodically Doesn't Work On 2010 Keystone RV Hideout Series M30 BHDS
  Yes; this could potentially be an issue with the solenoid and there is a way to test whether or not this is the cause of the issues. What you'll need to do is switch the wiring between the two cylinders to see if the same thing happens, but in reverse, which would indicate the solenoid being the problem. If the slideouts start malfunctioning when you're extending the slides, you can replace the solenoid with the Lippert Components Polartiy Reversing Solenoid # LC118246 . If nothing really...
  view full answer...
  
• Trombetta Slide Out Solenoid Replacement For RV
  Most likely you have a bad solenoid on your Trombetta Lippert slide out and would just need to replace it with the part # LC118246. It's very common that this style of slide out has solenoid issues and this is the known solution.
  view full answer...
• Troubleshooting Lack of 12V Power to Slide Out Solenoid
  If the valve on your solenoid was open then that would explain why nothing was operating properly. The valve being open would mean that the pressure would have been released. Since you closed the valve, as it is supposed to be, that is why everything is working great. I spoke with my contact at Lippert about the above and about you not seeing 12V going to your solenoid. He said that some solenoids will use 6V power instead. If your slide is working properly after you closed the valve then...
  view full answer...
• Polarity Reversing Solenoid Recommendation for 2008 Peterson Excel Slide Out
  The Lippert Components Polarity Reversing Solenoid by Trombetta # LC118246 that you referenced is the correct replacement. If you check out the picture I attached you'll see that the numbers you listed match the decal on the side of this. By the way thank you for giving me that info as it really helped make getting you the correct part easy!
  view full answer...
  
• Troubleshooting Lippert Slide-Out Only Retracting After Resetting Control
  I reached out to my contact at Lippert and he said it sounds like there could be a bad motor or harness on your trailer's slide-out. The one green flash you are getting indicates an issue with motor 1. He recommends swapping motor 1 and motor 2 wiring to see if the single green flash remains or if it goes to two green flashes. If it moves to 2 green flashes (motor 2) then the motor or harness is bad and needs to be replaced. We do have replacement slide-out motors available which I have...
  view full answer...

Do you have a question about this RV Slide Out Part?