Troubleshooting Lack of 12V Power to Slide Out Solenoid
Updated 09/17/2018 | Published 09/15/2018 >
Question:
The solenoid doesn’t have 12V going to it. The motor runs in both directions with the switch but the slides will not go out. I can close the solenoid valve and it works great. Any help would be appreciated.
asked by: James B
Expert Reply:
If the valve on your solenoid was open then that would explain why nothing was operating properly. The valve being open would mean that the pressure would have been released. Since you closed the valve, as it is supposed to be, that is why everything is working great.
I spoke with my contact at Lippert about the above and about you not seeing 12V going to your solenoid. He said that some solenoids will use 6V power instead. If your slide is working properly after you closed the valve then you should be good to go but if you aren't seeing any power to your solenoid that would indicate that your power wire is damaged somewhere between the power source and the solenoid. Look for any places where it is damaged or bent and replace accordingly and this should fix your problem!
Product Page this Question was Asked From
Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units
- RV Slide Out Parts
- Motor Parts
- Solenoid
- Lippert
more information >
Continue Researching
- Q&A: How To Test for Bad Controller on Lippert Ground Control 3.0 Electric Leveling System
- Shop: Lippert Polarity Reversing Solenoid by Trombetta for Hydraulic Power Units
- Shop: Replacement Lippert Leveling Control Brain for 4-Point Leveling System
- Q&A: Replacement Control Module and Control Panel for Lippert 4 Point Leveling System
- Q&A: What Fluid to Use with Lippert Hydraulic Jack Leveling System
- Q&A: What is the Recommended Hydraulic Fluid Level for Lippert Hydraulic Leveling Jacks?
- Q&A: Wiring Diagram and Fuse Location for the Lippert Ground Control 3.0 4-Point Leveling System
- Q&A: Troubleshooting A Lippert Leveling System That Won't Retract
- Shop: Camper Tie-Downs
- Shop: TorkLift Tie Downs - Custom Frame Mount - Front and Rear
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: Trailer Wiring Diagrams
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Search Results: trailer hitch
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Shop: Trailer Hitch
- Search Results: trailer wiring
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer jack
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Shop: Suspension Enhancement
- Shop: Brake Controller
- Article: 5 Things to Know About Weight Distribution Hitches
- Video: How To Choose Camper Leaf Springs
- Search Results: trailer leaf springs
- Shop: Base Plate for Tow Bar
- Video: etrailer VS Dexter Self Adjusting Brakes Comparison

