700-Watt inverter lets you use appliances and devices wherever the road takes you. Pure sine wave technology is perfect for sensitive electronics like HDTVs and computers. Changes your RV battery's DC output into clean AC power.
Features:
Specs:
This 12V inverter changes DC output from your RV batteries into AC power so you can plug in tools and appliances. Using pure sine wave technology, it creates clean power with low distortion, making it safe, efficient, and perfect for sensitive electronics like computers. Plus, the inverter can generate 1,230 starting watts and 700 running watts which is a great fit for small appliances and electronics.
The inverter includes 2 GFCI outlets for AC loads, positive and negative DC input terminals that connect to your batteries, and a port for a fixed-mount remote (sold separately). It has a function switch that lets you select different output voltages (100V, 110V, 115V, and 120V) and frequencies (50Hz and 60Hz). This switch can also turn the power saver on and off. Additionally, the power saving adjustment dial near the function switch sets the input and wake up thresholds for the power saver.
The system includes a number of safety features. It offers protection from over/under voltage, overloading, and overcurrent. The inverter also uses a heat sink process to protect from extreme temperatures, and an internal cooling fan removes excess heat from the unit.
For additional safety, installing a fuse between the battery bank and the inverter will protect your equipment from power surges. The Go Power 110-amp fuse block (sold separately) works with this unit and uses a slow blow time-delay feature to withstand surge current. This means it can handle short surges over 110 amps without blowing the fuse, which is great for devices with motors that require more energy to start.
The inverter mounts inside your RV in a dry location with ventilation. It should be installed in close proximity to the battery bank, but not in the same compartment. The DC terminals are wired to the battery bank.
There are 2 fixed-mount remotes (sold separately) that let you monitor and control the inverter from inside your RV.
For a simple, no-frills option, the Go Power GP-SWR-A Inverter Remote lets you turn your inverter on and off from inside your RV. It also has a LED which indicates the inverter's status.
For additional features, the Go Power GP-ISW-R-12 Inverter Remote provides LED indicators that display the voltage, output power, inverter status, power saving mode status, and fault conditions. It also has a power button that controls the inverter.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're going to take a look at the Go Power 12-volt, 700-watt, Industrial Pure Sine Wave Inverter. Now, this inverter will convert incoming DC battery power to usable AC household power wherever you go. It's an industrial pure sine wave inverter, so it does offer exact replica of AC power for your portable electronic equipment. It's perfect for medium-size loads like electronics or small kitchen appliances, and it'll run any device in the wattage range without interference. It's a very nice lightweight, low-profile design.On this end, I'm just going to go over what's on the end. Right here, has the on and off switch.
Here it'll have the dual ground fault outlets, AC outlets. Over here, it'll have a power save function switch and right here there's a power save adjustment mode. Right underneath there's three LEDs, those are the function LEDs. And if I turn around to the other end, right here is the DC input connectors, right over here is the chassis ground, and then right above it is the remote control port and terminal.Now, this does offer full overload protection. It is compatible with 12-volt systems.
Has a continuous output power of 700 watts, peak surge power of 1,230 watts. AC output voltage is 100 volts to 120 volts. Input voltage range is 10-1/2 volts to 16-1/2 volts DC. The AC output wave form, again is pure sine wave. Maximum efficiency on this is 91%.
The battery drain with no AC load is less than or equal to 1-1/2 amps. Does offer low battery alarm, low battery shut-down, and it does include everything shown here, the inverter itself.Comes with the two ring lugs. These will connect to your battery cables and allow you to connect it to the inverter right there. Also, a nice user's manual that'll describe how to install it and describe how to operate it. Weight on this unit is about 5.7 pounds.
And a measurement on it, the length from here to this end right here is 13" long, the width on it, here to here, is going to be 7-7/8" wide, and the total depth from the bottom to the very top is going to be 3-1/4".But that should do it for the review on the Go Power 12-volt, 700-watt, Industrial Pure Sine Wave Inverter.
Ratings & Reviews
We have had great experience with our Go Power 24 volt DC - 700 watt sine wave inverter. It has low idle power consumption and works great under 120 volt loads. We had bought another Go Power earlier which is a 12 volt DC - 300 watt inverter for a remote lighting application. These are quality inverters with good durability and reliable performance from our experience. I highly recommend particularly the low wattage models we have used.
I have this installed and the included remote does not work as described in the instructions. When not connected to shore power the remote shows the charger function on yet the instructions say this is not an option.
Also, I changed the power saver mode to 15 minutes from the default off. I didn’t see a change in the remote output after several hours.
Less than 10 days after I ordered this etrailer dropped the price $XXX.XX. That’s not insignificant and they wouldn’t do anything for me about it.
I installed the GoPower 3000w inverter/charger in my fifth wheel trailer. I connected it with three 12v deep cycle flooded cell batteries and a sub panel to send 120v power to all outlets in the trailer. The automatic switch in the inverter has worked flawlessly. Perhaps the best part is the E-Trailer customer support. They answered my calls, actually speak English, and stayed with me until my questions were answered
Super fast delivery
Installed last year in a horse trailer with living quarters. Using with a pair of Dakota lithium batteries. Works great. Powers Microwave with ease. love the ability to pull from battery while also using generator; i can run both microwave and coffee maker together like this.
Points of note:
1) When inverter is turned on there is a quiet weird chirp occasionally. If you're a light sleeper sensitive to sounds, be prepared for a "what is that?" if it is installed in the LQ area.
2) If batteries are full and i plug in my Furman generator (Costco purchased from Costco), the generator gets tripped in to overload when float charging is enabled. Not an issue when charging batteries.
This product is reliable and works well to the stated 400 watts when the load is steady. I like that this unit works well with my 29.4V DC battery pack (7S). Past 250 watts, even small surges will trip the unit off. At around 250 watts(steady) my quart compressor cooler will kill AC power out when it kicks on. It appears that the 600 watt surge rating is inaccurate.
Received it quick and was easy to insta ll.
The inverter works very well. The only reason I gave it 3 stars is because the front of the unit is made with cheap plastic. The screws that hold the electric outlet in the front of the unit is embedded into the plastic. The plastic broke the first time I plugged into the outlet. I was leaving in two days to go on a trip to Utah so did not send it back. I voided the warranty by opening the unit, reinforced the outlet by sandwiching the plastic front in between two pieces of aluminum and used screws to hold the outlet in place. Since doing this, everything has worked flawlessly.
I would not buy this item again due to the plastic front.
Delivery and unit came was a described. I di have to purchase additional Romex but looking forward to my increased power for my Toy Hauler!
This unit is well built and ready for 50 amp pass thru. Comes with built in 50amp circuit breakers and Romex clamps. Installed on our 2019 Grand Design Momentum and so far works great. Recommend the remote panel. Bob at GoPower was awesome with customer service and helped me set all parameters for lithium batteries. Sarah at etrailer was great and had shipped out an hour after I ordered to make my need date. I highly recommend GoPower and etrailer.
I finally received my Go Power IC3000 after a nearly three-week delay. Unfortunately, I missed my window of opportunity to get it installed this year, so I am not able to complete a review of the product at this time. I can say, installation is going to be quite a challenge. The item is large and heavy. Finding a suitable location that meets all the requirements is going to be difficult. The batteries are located at the front of the trailer, while the AC lines are on the other side of the basement. Since the inverter cannot be located in the same area as the batteries, I'm not sure I am going to be able to reach everything and maintain the 10' maximum length requirement of the 0000 DC cable. We will see what happens next spring. I will post a follow-up review post-installation if possible.
This was a great DIY project. I will be able to boondock and have all the essentials. The inverter/charger was the best addition to my package. I can use a smaller generator because the inverter/charger has power sharing. This is a great feature.
After 4 days of use this inverter easily does anything I need it to do, which is largely charging batteries when taking road trips. It handled my Dremel and 3/8 drill, as well. Didn’t try the grinder ?.
It’s well made with an all metal chassis, including front and rear faces – the only plastic is the black cover. It is substantial and heavy enough that it doesn’t look and feel cheap or breakable.
Overall, I like the unit and would recommend it.
My only strike against it is, IMO, a design flaw at Go Power. It is nuts to have the power connections on the back so close together. One of them should be located where the ground connector is. If one uses something more substantial than the #6 wire Go Power recommends and one should if the inverter is more than about 3 or 4ft from the battery. I am using #6 CABLE for a 9ft run. The plastic caps make it difficult to impossible to use lugs made for more substantial cable, but the proximity of one to the other makes it a safety concern to remove the caps. I had to file one lug more narrow to make it fit inside the plastic and left the other uncovered.
Very good service. When I call receptionist was delightful
Good advice to help decide which inverter is right for us. Really fast shipping and delivery.
Great pricing, fast shipping. Just what we need to complete our customers RV solar system set up. Thank You etrailer for helping us get it done.
We are currently working on hooking up the inverter we ordered from etrailer for the maiden voyage in our new trailer. It appeared these items would not be arriving before we left, but after a quick phone call to etrailer and a conversation with Steve Z. in customer service our inverter was on it's way by 10:00 am that morning. It did indeed arrive in 2 days giving us time to hook this up. We were thrilled as we wanted to put this trailer to work off the grid. Great service. Thank you so much.
Ordered Monday night at 6:30 pm and it showed up Thursday at noon with the free shipping option. Can’t beat that! Now I get to install over the weekend instead of waiting until the original arrival date of Monday. Will give 4 stars for now until it’s installed and working. Hefty unit at 50 lbs. install in my 2015 Amped 28FS looks like it will be very straight forward. Thanks etrailer for the quick shipping. Now I can’t wait to do some serious boondocking especially when my solar is installed and I can minimize the generator running!
Works great, the unit is powering a work shed in the backyard. The Inverter is paired up with 400w of solar and two battleborn 100a batteries. The unit replaced a 3000w inverter from another company that fried twice within a year.
One year + later, this inverter is great! I have it connected to two battleborn lithium batteries. We can run our TV although we don’t much, our Microware, or our coffee Kirin machine - of course not all at once. The fan is a bit noisy but it only fires up when drawing heavy from the inverter. Love it and recommend it.
It works great with all my devices, and affordable. Able to run a 1500 W microwave by adjusting the front mounted dip switches to 115 Volts. We make a pot of coffee in the morning with our Keurig. Run our countertop ninja oven, induction hot plate, bread machine, Insta pot, charge both 500 WH bicycle batteries… but remember we have to keep the load below 1500 Watt, basically the heating loads one at a time.
Hope to install today
Just received the product. It arrived fast and in good shape. Will know more about it after it gets installed.
Nice quality as usual from Go Power, works terrific.
Do you have a question about this Power Inverter?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.