Redline 2" x 7/8" Rubber Boat Roller Wheel - Qty 1

Video Transcript for Review of Redline Boat Trailer Parts - Rubber Boat Roller Wheel - RE27FR

Hey everyone. I'm Ellen here at etrailer.com and we're going to be taking a quick look at the red line, rubber boat roller for your boat trailer. So this helps to allow your boat to roll on easily onto your boat trailer, so it can move without any friction. It's just made out of a hard rubber material, so it's not going to mar up the bottom of your boat or shouldn't really leave any marks or anything like that. Let's go over and look at the size of this and take a little closer look at it overall. So you can see, here's our little guy.

Doesn't really have much give to it, so it is going to be a nice, hard rubber. As far as the overall diameter, it's about two inches from side to side, two inches in diameter. And then the width is about seven eighths of an inch going to this middle, almost the axle part of it.The inner diameter does have a nylon bushing in there. You can see it's pushed through a little bit more on this side than the other, that inner diameter of the bushing is a quarter of an inch. So quarter-inch hardware should work just fine for that.

Should be a standard size for a standard boat trailer roller, and again, help to alleviate a lot of the pressure or a friction that you typically experiences that boat's going to roll on into place. So I hope this video has been helpful in deciding if this is the right part for you. Again, I'm Ellen here etrailer.com. Thanks for watching.