Most Popular Pop Up Camper for 2021 Chevrolet Silverado 1500

So far so good. It took about an hour to swap out the two jacks. New jack lifted the trailer without issue. I

Great jack! Easy to install and works every timeno problems

if I had to rate this upgrade in difficulty one being the easiest five being the hardest, it would be a one. Super simple. Take the nuts and bolts off your old hardware and install the upgrade in its place. I read some of the reviews were people were annoyed with the counter clockwise rotation and the bolt sticking out too far. I really didn’t see a problem with either. I know you’re not supposed to use a drill to extend and retract these but I always have. I suppose as long as you’re not torquing the heck out of the adjustment screw you shouldn’t have any problems. I always put a small flat 2 x 6 piece of wood under the foot of each one of these. It seems to add quite a bit of stability.

The jacks themselves have worked great, they keep the trailer level and solid during our concession events. I just had them mounted to the trailer so I don't have to put them in and out at each event. The jack handles leave a bit to be desired so I use a 20v drill w/ a 3/4" socket to run them up and down.

Fast Shipping and delivery, worked great as replacements for my old worn out stabilizers

Quick shipping. I will be ordering more parts as I need them for our RV.

The powerhead is very large and extends forward, which has caused it to impact upon two different vehicles when backing the trailer. The power function is now useless, and I am using the manual crank to raise and lower the jack.

Sturdy jack, easy to install. We installed it facing to the driver's side so we can still put our tailgate down. Very powerful jack, only drawback is it is very slow.

I purchased this jack to replace my tired 10 year old camper jack . I ordered it at 10:00 AM Monday and as promised by Ian it was at my doorstep on Friday just in time for my weekend getaway . Installation was a breeze . I gave the product a 4 out of 5 for a few reasons . First , I was not able to see the manufacturer of the jack before receiving it . Which made name brand comparison pricing difficult . However I feel pricing was on target . Second , I feel that the jack should come with a battery terminal end connector and new mounting bolts with the hardware that was included . This didn’t pose any difficulty to me as I had hardware at hand but for some it will mean a trip or two to the hardware store . Third , once installed , at least with my truck and trailer , unless the truck and trailer are perfectly aligned and level the jack motor gets in the way of opening the tail gate . On first use I noticed it was much slower than my original but the strength made up for it . This jack had no difficulty or hesitation lifting my truck and trailer for load distribution and anti sway bar installation . I would recommend etrailer and this product . Time will be the final test of its durability .

Ok.... the customer service from ETRAILER totally saved the review! These guys are incredibly awesome. I ordered 2 of the jacks. The first came with a broken housing cover , the light had beed disloged, and the up down switch was wired backwards. (Up would put the jack down and down would put the jack up) Solution? Glad you asked! I contacted ram about the cover.... waiting! The light was easy to correct, just had to slide it back into the slit that holds it. Switch, well.... if-your2 not comfortable with wiring, I recommend not even attempt to rewire. I just popped it out of the cover, twisted 1/2 turn, popped it back in. Total time to correct.... 8-10 minutes. Total time to install, 15 minutes. Total job less than 30 minutes. Would I recommend this jack... YES. Despite a shipping issue to crack the housing ... its easy to install, price right, powerful. I dont have to hand crank. Simple correction to the switch. And they could use some r&d improvment on the light... but excellent jack! It does what i meeded it to at an affordable price!

Works great when it works. I really like this Jack and wish I could give it 5 stars. I only gave it three stars because every time I use the Jack it blows a fuse when I try to hook up the w/d hitch. My trailer only ways 4k with 400 tongue weight which would make it a two star but it could be my wiring so I gave it a three, and don't expect the level to make it more than a couple of trips. It clouded up then broke within two months of install.

Overall the product does exactly what it's intended for and works well. I however assumed that this would be a simple R&R for my camper and did very little installation research other that the video provided on etrailer' s website Sadly it did not fit. Not at all. I didn't take into account that have a double framed hitch toyhauler. The baseplate on the factory leg was a TRIANGLE.....this unit was ROUND. Also the primary shaft was thicker than stock and would not drop down into place I know modifying is frowned upon, but I found that ALL powered hitch legs I found have round mounting plates and it's not mentioned the leg tube is thicker than OEM? Since NOT having a power lift wasn't an option for this camper application...too heavy in the front when ATVS loaded to lift for setting the equalizer hitch tension bars, I proceeded to modify by cutting the rear rounded mounting base ... square. Took off about 1/2 inch. Then I took my metal Dremel sanding bit and increased the hitch leg hole diameter slightly. Took about 1 hr. Dropped it in. Wired it. Tested it. All good. If you can't post this I understand, but take note that some of your website descriptions may need to be enhanced. Thanks!

Out of the shipping box and installed in 30 minutes. Excellent fit. Thank you!

Very heavy duty better than the oem jack that was replaced

I should have got one years ago. I only use it when it's connected to the truck with the engine running. This I believe gives me full power. It has enough power to raise the trailer when connected to the truck to get the anti sway bars attached. Sure beats all that hand cranking.

The alternate power setup makes its slow rate of rise necessary which would be good if my lithium batteries went low. To avoid battery problems be sure to add an inline battery disconnect from the trailer power when using tow vehicle power. I simple added an inline fuse that could be removed should I need to use the tow vehicle power.

etrailer did a great job. There was a problem with the shipping from UPS. etrailer sent me an email to see if I received my electric tongue jack. I hadn't got it. I responded and they looked into the missing jack and found out where it was and it was delivered. As for the jack it was an easy install and works great. Great customer service.

Easy installation, reasonable price, works great! Much to my surprise, our trailer had a 2.25" top hole and a 2" bottom hole. This jack fit fine. The lights are helpful.

The trailer jack works perfectly and was easy to install

This is what I needed. I Wanted a little more lbs. of lift so I could lift my truck for weight bars and such. I have a 2014 Rockwood A Fram and needed the mounting holes to line up. After some research, I found Stromberg jet-3755 worked perfectly. I have used it for a year now and no problems. Easy to set up and use. Thank you etrailer

LOOKIN GOOD, After one year, I can only distantly remember my plight with the problem of leveling my 1500 dodge (light rig) with the 30 ft. travel trailer. Your simple, most economic solution (and I did it myself in 15 min.) by adding the rubber supports to the rear suspension makes me the straightest shooter on the road, thanks! Ken

Great customer service and shipping follow up.

Great looking jack and very well built. I am very pleased with it's construction, and ease of use. I just wish I had the speed nut.

Replacement for bent camper stabilizer jacks, these work great.

Hello, Please see pics below of broken weld on jack. The jack was just installed and in use for about 7 days and noted the broken weld. Jack functions as described, however, we question the durability of the jack.

Definitely has the power I need however I can't open my tailgate when my camper is hooked up. 5 stars for power.

Works great as a stabilizer. I have a 38' trailer and I use screw jacks to level the trailer. Once the trailer is level I lower the stabilizer jacks to eliminate any movement. With this combination the trailer does not move one bit.

There's not a lot to say. The first Stabilizer carton was damaged to the point the carrier couldn't even find the Stabilizer. etrailer.com was very cooperative & sent a second unit out right away. Although the second shipment packaging was damaged all parts were there and undamaged. I installed the unit and it is so so much better, quieter and faster than the old unit. I highly recommend both Lippert and etrailer.com

After I got lazy and did not fully lift the rear Jacks on my 5th wheel trailer I had to move it and needless to say destroyed them. The new ones I got from Etrailer were just what I needed, 10-15 minutes to bolt both on they extend and retract very smoothly. I couldn’t be happier. (Unless I didn’t get lazy and cost myself some cash)

I am very impressed on the customer service and the way the follow up on your order. It is very important in good client customer relations and I will be getting more from etrailer Also the quality of the product is above what I expected so thank you on that I do and will recommending e trailer to any and everyone thank you e trailer for such an outstanding experience Joey Glover

I am giving two stars because it works. However, the mounting plate is not level which made the jack not stand straight up. It leans slightly backwards. I didn't realize this until I went to install it and broke a bolt in the hitch. I would buy again, however I would look it over very careful and if anything looks wrong or out of place, return it.

The cover over the light on the jack was not attached and there was a piece broken on the case. I thought of sending it back but decided quicker and easier to just repair it myself. See photo

These work well as advertised. It was as easy fit and direct replacement for my existing ones that had seen better days from the previous owners.

I upgraded my '98 sportsmen from tripod stands to these scissor jacks.Setting up is so much easier now. The jacks are very sturdy, fairly priced and were easy to install.

It installed very easy. For a 2500lbs jack, it seems a little light weight. It does lift the trailer but seems kinda wobbly because the post size is so small. Other than that it works as advertised. Thank you for getting it to me so fast.

I just installed my new JET-2500 trailer tongue jack in less than 15 minutes. The light and extend/retract work great. I was not sure if an adjustable drop foot is available for more length but do not think it is needed. This is second purchase, first being Equalizer hitch system which is also even better with electric jack. Etrailer exceeds customer expectations by follow up email and definite concern to keep their customers satisfied. Great Company! Thank-You Ron Williams

I drilled two 3/8" holes in the top of the rail and used two stainless bolts to hold it on. Works very well for this application. It folds and holds the trailer for loading, and if I have to leave it somewhere, and don't want the tongue sitting on the ground. I used it on a Harbor Freight 4x4 trailer I am building to pull with my Can-Am Spyder. Love it!!!

I purchased this jack for my 2010 Escapade Elite trailer. I finally installed it yesterday. After a quick and minor modification, it fits great and funcltions like a charm. I highly recommend this product to other MC trailer owners. Thanks, etrailer.com for the quality and price!

The product is easy to install. It should be redesigned to allow more space between the trailer and the ground pad when in the travel position. There is interference between the pad and trailer that does not allow full locking in the travel slot. See pictures. A spacer for mounting would improve this feature.

I'm using the jacks to level the tailgate on my trailer so it can be used as a deck. They are easy to adjust for terrain variations