Best 2012 Toyota Sienna Trailer Hitch Ball Mounts

Excellent! I use this to pull our pop up camper with our minivan. I love how it can go in upside down to give use a little more height.

I bought a hitch, stinger, ball and wiring harness for my 2004 Toyota Sienna. It was delivered fast, it was the right stuff, and it fit, just like it was supposed to. It really was as easy to install as it looked in your video. The video was immensely helpful too. The video showed me exactly what I needed to know to get my hitch installed correctly and it gave me the confidence to order online and do it myself. The only drawback is a loss of ground clearance but you warned me fair and square up front about that, so I can hardly complain. Thank you, that was a good investment.

Strong and seems to be well made and well finished. One-inch ball mounting hole. I used this for a Curt hitch mounted on a 2014 Forester and pulls a small Harbor Freight trailer. Perfect height and trailer is level. Warning - don't get their hitch pin, it does not have a hole for a cotter pin, only a weak clip that I would not trust.

The hitch and ball mount are excellent quality. My concerns are twofold. The hitch is so heavy that I had to take it to my mechanic to have it installed. Minor cost and inconvenience, but the hitch for my previous F-150 was just as sturdy, but easy to install myself (albeit with higher ground clearance). My concern about the ball mount is that the factory told me erroneously that it could not be reversed for a drop, so I returned it. This order is for the replacement after I was finally correctly told it could be reversed and how to do that. Ball mount would have been a 3 for that reason, and overall hitch and ball mount quality a 5. So I averaged them.

I have two of these. My first I bought two years ago. I very highly recommend this Curt Class III Ballmount 2" Drop because of its price, durability and quality. I towed various class 3 loads with ease and confidence with this ballmount. It slides into the hitch and does its job without fail. It looks excellent after towing a load. etrailer's price is about as good as it gets and delivery is very speedy.

I hooked up the draw bar today for the first time to the trailer that I built and the hitch I installed. The draw bar uses a cotter pin that slides on the bolt rather than going through a hole to mount the bar to the hitch. I have never used a sliding on pin in anything - I've only used those that go through a small hole matching the pin. This includes my farm tractor and other tools. I hope it is secure because it does slide on easily. The bar itself appears nice and strong.

This is an average product. Unfortunately it si too short to use on my 2018 Rogue with Draw-Tite hitch 36542. I will have purchase a longer ball mount such as Curt 45519.

Plugged right in. Worked great on my 2008 Toyota Sienna Van. Great information on correct size. Easy. Thanks

Flipped it for hight on a Toyota Sienna 2015 - Works Great!

This is a great all-purpose hitch. I've used it to mount a heavy-duty bike rack and a steel T-rack to carry a canoe as well as lumber. Most recently I hauled 5 x 8 cargo trailers full of plants, then furniture for a 600-mile move. It was simple to use, problem free, very strong and sturdy. Now that I live on some acreage, I see a trailer in my future, so this will get a lot more use. I drive a 2013 Tacoma, so this is a good size hitch at a good price with sufficient capacity for my needs. I do use a key lock for the hitch as well.

Just your basic ball mount, the product is just like most 2” Hitch ball mounts, the service wasn’t very good though. Ordered on June 15th (product was in stock) took them 6 days to send it out, took another 6 days in shipping and got all the way to my post office two days before leaving on vacation (I needed it for the vacation) and the post office said “box was empty and they notified seller” etrailer sent a new one (got here a week after my vacation) in a damaged box (packaging is horrible, little bit of paper in a box with a 5 lbs ball mount) almost lost this one too. I don’t believe I’ll be using etrailer in the future (had issues before)

I bought the Curt D210 Multipurpose Ball mount to raise the level of a Kuat platform bike rack with extender for 4 bikes from my Drawtite hitch on a 2007 Toyota Sienna. Service from eTrailer was superb, the mount is extremely well-built, and it fits my Sienna/hitch like a glove. We used the rack with 4 road bikes on two trips this week-end and it worked flawlessly; not even a minor scrape through many driveways and turn-ins. The system does move the rack back a few inches; 50.5" from the bumper, so we needed a red flag on the end (at least in MO). This is the only nit in an otherwise great product.

We sold our small motor home and purchased a small travel trailer. This hitch provided a perfect solution to how to use our bike rack while towing the trailer. It even allows room for the pickup tailgate to be lowered without removing the bikes from the rack. The hitch is very hefty with a high weight limit - plenty for the GVW of the trailer (7,000#) plus 125# of rack and bikes.

fits like a glove. works perfectly

I wasn't sure what type of ball mount I needed for my new Mazda CX-9, so I had to call a representative. The first time I called, the very knowledgeable gentlemen told me exactly how to measure my SUV to figure out the drop I needed. I called back the next day and talked to a lady who helped me figure out exactly what I needed. This is my second purchase from etrailer. The first was a hitch for my old Honda Odyssey, which was also a great experience. The employees are so helpful, the video tutorials on the web site are fantastic and the prices are great. etrailer.com is the first place I go to look for trailer and towing supplies!

etrailer shipped fast and had great communication. The hitch was built very well look like a quality product and was just what I needed. The 5 inch rise was perfect for our 2009 Toyota sienna.

Paint on draw bar was a little questionable. But it came that way from the manufacturer! Had nothing to do with Etrailer quality of service!

Love the ball mount. I have a Toyota Sienna and the rear seats recess into a well, therefore the receiver hitch much go underneath the well. This means the ball mount enters the receiver approximately 10 inches off the ground. By using the ball mount to raise the ball, this makes the ball around 22 inches off the ground, which is recommended height for my trailer. My only regret is that I did not request you attach a ball as I did not have any wrenches large enough to fasten it. Again, the mount is great. Thanks, Ron Baker

Prompt delivery, looks great.

Excellent hitch easy installation.It only took me about an hr and half to install from start to finish

Came quicker than expected. All good .

The welding splatter found its way to the hitch pin hole and it took me some time with a Dremel to clean it out so the hitch pin would slide in.

This is exactly what I needed for my front end mounted receiver.

As advertised and quick delivery, I am an Etrailer fan!

I had trouble finding a 4-3/4" rise at any local stores. Etrailer shipped it out in a reasonable amount of time. Using this to pull a small trailer behind a Toyota Sienna and needed the 4-3/4" rise. Packaging needs some thought. 2" ball was coming out the side of the box when it was received.

tl;dr good experience with warts. The etrailer-branded ball mount kit I ordered was back-ordered for a month, which was fine. Eventually Ashley E told me it would be a _second_ month. Not fine. She helped me configure a new order of third party parts. Shipped in one day. Great! Not great: Parts were just thrown in a box with no protection. UPS did their usual thing. Paint was chipped in a couple of places; would surely rust. I'll shoot these spots with some spray paint before installation. Hope that's a fix. I can't afford to diddle with a return.

The information and resources on your web page are truly outstanding :) It made ordering the right products seamless. Order executed and products received i.e. one happy customer........ Remarkable

As advertised and what I needed thanks.

I purchased the AMSC10 because I needed a 10" drop hitch to tow my lowboy enclosed trailer with my lifted Toyota Tundra. I tried several other types of hitches with this towing combo and I was always disappointed. Mostly because of the fit/sloppiness of the ball mount into the receiver. This would cause a lot of noise and the feeling of the trailer "bucking" while hitting bumps and such. The other hitches that I tried were those cool aluminum ones, both a fixed one and an adjustable one. Although they were pretty, both left me very disappointed. The shipping for this hitch from Etrailer was fast and efficient. I received emails informing me of my order status throughout the whole process. Upon receiving my AMSC10, I tested it out and found it to be a much nicer fit into the receiver. Once I hooked up to the trailer and began to tow, the difference was extremely noticeable. This hitch is quiet, it doesn't buck, and in fact, comparatively, you wouldn't even know the trailer was behind you unless you looked. I am actually really excited about towing with this hitch. I know it sounds goofy, because it is, but it makes the task so much more pleasurable with the cushion ball mount. I'm already thinking about buying the 8" drop for my normal trailers.

This is such a great idea! It works flawlessly with my Jeep Wrangler and my Offroad trailer. The dampening incorporated into the hitch makes my ride so much smoother. I used to hear the clanking, tapping and banging while braking and while trailering offroad, but not any more! I highly recommend this hitch to anyone.

Quality, strength and value describe not only this product but the entire etrailer experience. Product selection features, clean website and buying confidence. This ball mount is exactly what I expected and the express delivery was a bonus. This is my second experience etrailer and it probably won't be my last.

Fits perfect. Now my trailer is not hanging down anymore. It's level when it's hooked up. Thank you.

Very sturdy product but hole for the ball was drilled off center - shifted 1/16" to the side. etrailer kindly replaced the original after seeing a picture showing the fault.

Again, Will the eTrailer rep really helped me get exactly what was needed for my application which was a little out of the ordinary. I could tell he had the knowledge and experience to direct me to the correct solution.

Fits our VW Touareg perfectly and allows us to tow a variety of things now. As can be seen in the pictures the hitch has a +5-inch gap between the bumper and the vertical adjustment pillar and the trailer itself is out further so there's enough room to get to the rear hatch and maneuver the vehicle/trailer.

Picked up my teardrop in ABQ on 2/17/23, and the Curt ball mount lined up perfectly with no drop/rise, and the extra length gave clearance for my rear door mounted spare tire. This mount is a beast, and the "overbuilt" nature of it gave me confidence that my Bronco would tow the teardrop easily. I also got the Curt Echo wireless brake controller, which synced easily to my phone and was easy to install, set up, and use. Overall a great towing experience, thanks to etrailer and Curt!

The hitch on my Sienna is mounted low and recessed under the bumper so this ball mount has been perfect for the right height and reach for my boat trailer to ride level. etrailer is the only place I found what I needed. Actually I always look there first because they have such a good selection.

The ball mount dimensions and quality were as advertised. Shipping was extremely fast, to Hawai'i! Very satisfied with this purchase.