Will Biker Bar Fit 2022 Indian Chieftain Limited
Question:
Looking at the transport bar set up. I have a 2022 indian chieftain limited, need the bar for the bike with the bracket. Everything is listed for Harley Davison.
asked by: Paul M
Expert Reply:
Hey Paul; B&W hasn't tested the 2022 Indian Chieftain Limited but it may fit the # BWMC2304. To find out if it will fit you will have to take some measurements. A two piece motorcycle tube frame is needed for the Biker Bar to clamp onto. The diameter of each frame tube must be at least 1.125" and no more than 1.5".
Check that there is nothing hanging down below the tube frame, such as a motor, transmission or exhaust. With the rider sitting on the motorcycle, the distance from the side of the frame tubes to the ground must measure between 5" and 6.5".
The distance form the outside edges of each frame tube must be no less than 10" and not more than 14.5". Take this measurement where the Biker Bar will be attached. There must be 1/2" of clearance between the motor, transmission, and primary drive to allow clearance for the Biker Bar clamps.
If you find it won't work you will need a more traditional setup with a wheel chock. You can use the E-Track # e95VR, Wheel Chock # 3481731, Tie-Down Ring # 59131, and Strap #EM59136 to secure your bike.
(click to enlarge)
Products Referenced in This Question
CargoSmart Motorcycle Wheel Chock for E Track or X Track Systems - 7" Wide Tires
- E Track
- E Track Wheel Chocks
- CargoSmart
more information >
etrailer Horizontal E-Track - Galvanized Steel - 2,000 lbs - 4' Long
- E Track
- E Track Rails
- Horizontal
- 4-7/8 Inch Wide
- 2000 lbs
- 4 Feet Long
- etrailer
more information >
Erickson E Track Strap with Ratchet - 2" Wide x 12' Long - 1,165 lbs
- E Track
- E Track Straps
- 2 Inch Wide
- 1000 lbs
- 12 Feet Long
- Erickson
more information >
Product Page this Question was Asked From
B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson 1-1/2" Custom Frame
- Motorcycle Tie Down Straps
- Trailer
- Clamps
- Tie Down Anchors
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: military dismount
- Shop: Brophy Angled Motorcycle Wheel Chock for E-Track
- Shop: Vehicle Lights
- Article: Trailer Maintenance Schedule
- Video: Snap-Loc E Track Tie-Down Anchor Feature Review
- Video: Checking Out the E-Track Plastic End Cap
- Video: All About the Grease Seal
- Search Results: motorcycle
- Search Results: military discounts
- Search Results: wheel chocks
- Search Results: em07506
- Search Results: e46rr
- Search Results: e track
- Shop: Snap-Loc E Track Tie-Down Anchor - Square Mounting Hole - Bolt On - 1,000 lbs - Stainless - Qty 1
- Shop: Snap-Loc Tie-Down Anchor Kit - 1,000 lbs
- Shop: Erickson E-Chock Wheel Chocks for E Track - Powder Coated Steel - Qty 2
- Shop: Erickson E Track Tie-Down Anchor - 360-Degree Swivel - 2,000 lbs
- Shop: Brophy Stop Plate for E Track - 8" x 8" - Black
- Shop: CargoSmart Motorcycle Wheel Chock for E Track or X Track Systems - 7" Wide Tires
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: How to Charge Battery for Fridge Using Alternator and Solar Power
- Video: etrailer Horizontal E Track Spec Review
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Article: Trailer Wiring Diagrams
- Video: etrailer Horizontal E Track Spotlight
- Video: Review of Brophy E Track - E Track Wheel Chocks - BR26MJ
- Video: All About the etrailer Horizontal E Track
- Shop: Brake Controller
- Article: How to Measure for Trailer Hitch Drop
on Tie Down Anchors
