Kinedyne Tie Down Anchors ET8730 Review

content loading



Customers compare ET8730 to these similar products




Products Featured in this Video



Review of Kinedyne Accessories and Parts ET8730


Today we're going to be taking a look at the E-Track Plastic End Cap. The plastic end cap is going to give a nice finishing touch to the installation of your floor-mounted E-Track system. The end cap is going to prevent feet, cargo, and equipment from catching on the end of the E-Track. This is designed for use with the horizontal E-Track. A few measurements to go over with you real quick. The overall length measuring from edge to edge is going to measure right at 5-1/4 inch.

The overall width is going to measure 3/4 inch. Then the overall height, that's going to measures 7/16-inch tall. Now, the mount holes on this unit are about 1/4 inch in diameter, so they will accept a 3/16-inch diameter screw. Hardware is sold separately. Those mount holes are going to be separated apart from one another on center by 4-1/2 inches. This would mount at the end of your E-Track system.

I have a piece of E-Track right here. If this was mounted on the floor of a unit or of a trailer or whatever, you would take the plastic end cap, butt it right up next to the E-Track system. You see how it lines up perfectly and it provides a small ramp up to the E-Track which, again, this is going to prevent feet, cargo, and other equipment from catching on the end of the E-Track system. That's going to do it for today's look at the E-Track Plastic End Cap.


Questions and Comments about this Video

add comment

Info for this part was:

Video Edited:
Dustin K
Video Edited:
Chris R
Installed by:
Cole B
Installed by:
Randy B
Installed by:
Jacob H

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.