How To Operate Middle Jacks Of A Lippert Ground Control 3.0 Leveling System
Question:
How can I manually lower the center stabilizers 6 point system? Manual mode only shows front and rear. It is on a 2015 Jayco pinnacle 5th wheel.
asked by: Mike
Helpful Expert Reply:
They easiest way I've found to operate the legs of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System # LC675817 is with the Lippert OneControl monitor if your trailer has it installed. This monitor will allow you to select either jack and manually adjust them.
If you have the standard control panel # LC421484 then you would need to put the system into error mode by pressing the "LEFT" (Fig. H) and "RIGHT" (FIG. I) buttons simultaneously. This will then allow you to operate the middle jacks manually. The manual mode you're referring to will only allow you to operate front or rear jacks.
(click to enlarge)
Products Referenced in This Question
Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Controllers
- Control Panel
- Lippert
more information >
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Bluetooth Control - 6-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 6 Jacks
- Lippert
more information >
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Andersen Ultimate Connection Adapter for Factory Gooseneck Hitches w/ Pop-In Balls
- Shop: Correct Track Trailer Alignment and Lift Kit - Tandem Axle
- Search Results: gooseneck hitch
- Shop: Correct Track Trailer Alignment and Lift Kit - Triple Axle
- Shop: Correct Track Trailer Alignment and Lift Kit - Single Axle
- Search Results: lc87120
- Q&A: What Size Bolts are Normally Used For Installing Fifth Wheel Rails
- Shop: Hide-A-Goose Performer Gooseneck Hitch Ball with 2-5/16" Diameter - 1" Rise
- Shop: Hide-A-Goose Gooseneck Hitch Ball with 2-5/16" Diameter
- Shop: Trailer Wiring
- Shop: Replacement Support Arm Assembly for Solera Flat RV Awnings - 69" Long - Black - Qty 1
- Shop: Trailer Hitch
- Search Results: lippert ground control 30
- Q&A: Wet Bolt that is Long Enough to be used with Correct Track Lift Kit
- Video: The Low-Down on the Equalizer Suspension Bolt 4-1/2" Long
- Search Results: door handle
- Search Results: al77cv
- Search Results: hepvo
- Search Results: alpha systems
- Video: What to Know About the Replacement Wet Shoulder Bolt
- Video: Lippert Components Trailer Jack LC342610 Review
- Q&A: Does Correct Track Lift Kit Create Additional Width that Allows Leaf Spring to Move Side to Side
- Shop: Brake Controller
- Q&A: Should Equalizer Hanger Be Installed First for Correct Track Trailer Alignment and Lift Kit
- Q&A: 2021 Highland Ridge Mesa Ridge 284RLS Lift Kit Options
- Q&A: Is There Any Way to Control The Middle Jacks On The Lippert Ground Control 3.0 Independently?
- Q&A: Lift Kit Solution to Allow Fifth Wheel Trailer to Sit More Level When Towed